Measurement Guide Agilent Technologies E7495A/B - TRS-RenTelco

Getting Started
Your First 15 Minutes with the E7495A/B
Your First 15 Minutes with the E7495A/B
Spend 15 minutes getting acquainted with the test set:
• “Get to Know the Layout of the E7495A/B” on page 34
• “Install a Battery” on page 37
• “Practice Using the Three-way Power Button” on page 37
• “Make Your First Measurement (Two Port Insertion Loss)” on page 38
Your E7495A/B analyzer is fitted with a transflective screen, which is viewable
under all lighting conditions. If you are using your E7495A/B analyzer in bright
lighting conditions, for example, in direct sunlight, avoid the temptation to shield
the display from the sunlight. In bright lighting conditions, the display is brighter
and easier to read when you allow the light to fall directly on the screen.
Getting Started
CAUTION
The maximum power for the RF In port and the RF Out/SWR port of the test set is
+20 dBm (100 mW). When directly coupled to a base station, the test set can be
damaged by excessive power applied to any of these ports.
To prevent damage in most situations when you directly couple the test set to a base
station, use the high power attenuator between the test set and the BTS.
Chapter 1 33