Measurement Guide Agilent Technologies E7495A/B - TRS-RenTelco

GSM and EDGE Analyzer
GSM and EDGE Analyzer
Optional GSM and EDGE Tx Analyzer Measurement Settings
results. If your measured TS Power is outside your specified limits, the numeric
results reported in the metrics portion of the screen will be displayed in red, and the
Limit Failure will be indicated by “(F)” after the results.
To Set the TS Power Limits:
Step
Notes
1 [Setup]
2 [TS Pwr Limits]
3 [Limits]
4 [On] or [Off]
5 Set the upper limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [dBm]
6 Set the lower limit.
a. [Low Limit]
b. Enter the number on
the numeric keypad.
c. [dBm]
Setting the I/Q Offset Limit
You can set an upper I/Q Offset Limit for your Measurement results.
If I/Q Offset Limit is turned On, and your measured I/Q Offset is below the limit
you have specified, the numeric results reported in the metrics portion of the screen
will be displayed in green, and the Limit Pass will be indicated by “(P)” after the
result. If your measured I/Q Offset is above your specified limit, the numeric result
reported in the metrics portion of the screen will be displayed in red, and the Limit
Failure will be indicated by “(F)” after the results.
358 Chapter 12