Measurement Guide Agilent Technologies E7495A/B - TRS-RenTelco

One Port Insertion Loss
Measuring One Port Insertion Loss
To Clear the Measurement Calibration Data:
Step
Notes
1 [Setup]
2 [Clear Calibration] This will clear the calibration for all three one-port
cable measurements.
Displaying Location Information Using GPS
If you are making a One Port Insertion Loss measurement, you can use GPS
Location data to verify your location. For additional information on the GPS Data
function, refer to “Displaying GPS Location Data” on page 458.
To Display GPS Location Information:
Step
Notes
1 [Level/Location]
2 On [Show GPS
Location] select On.
Displays GPS satellite location information. Uses the
internal GPS to capture the location at which a
measurement is made. The GPS information can be
used to return to the same location. The Time Ref
(Freq/Chan/Time Ref mode) button must be set to
Internal GPS for this function to be active.
Information logged includes longitude, latitude,
altitude (feet/meters), and the number of satellites
tracked.
Each time you press this softkey, the selected option
changes.
3 Highlight [On] Toggle to [On] to display GPS satellite location
information. Toggle to [Off] to remove the location
information
One Port Insertion Loss
NOTE
If you prefer to have an electronic copy of the location information, see “Saving
Data” on page 465.
Chapter 2 51