INSTRUCTIONS FOR INSTALLATION AND OPERATION elba

More documents

Recommendations

Info

Page 20 w w w. d r o o f f - k a m i n o f e n . d e TECHNICAL IN<strong>FOR</strong>MATION RATED THERMAL OUTPUT The actual thermal output of a stove depends on the amount of fuel with which it is actually stoked. The "rule of thumb" is: 1 kg wood = 3 kW heat output. The rated thermal output is stated on the plate attached to the stove. The rated thermal output is the thermal output which is determined by testing a stove to EN standard and then stated by the manufacturer. To achieve this rated output, a certain defined amount of fuel has to be burned. This amount is stated in the data sheet "Technical Information". THERMAL OUTPUT RANGE Every wood burning stove has a range of thermal outputs. Your stove will also function perfectly at ouputs which are less than the rated output. The high quality of DROOFF stoves even permits outputs which are slightly higher than that rated. Less fuel means a lower output, more fuel, a higher. This flexibility makes our stoves more economical. The thermal output range is stated in the current instruction booklet. Ensure that your stove is not overheated either for shorter or longer periods of time. Damage caused by overheating is not covered by the guarantee. Please refer to the section entitled "Guarantee". Always operate your stove according to the instructions and stoke it only with the correct amounts of fuel i.e. no more than you need for your actual requirements. Do not use only the air slides to control the heat emitted by the stove, but also vary the amount of fuel you burn. The stove is designed for intermittent use. Do not overheat it, even for short periods of time. DROOFF Kaminöfen — Feuer aus dem Sauerland
TECHNICAL IN<strong>FOR</strong>MATION Page 21 w w w. d r o o f f - k a m i n o f e n . d e ROOM-HEATING CAPACITY Room-heating capacity in m 3 4 kW 8 kW Heat requirement suitable 62 182 less suitable 39 105 unsuitable 25 71 According to DIN 18893, the above mentioned room volumes apply for rooms which do not comply with the legislation on thermal insulation. Lower capacities are sufficient for rooms of the above volumes which comply with the legislation on thermal insulation. APPROVED FUEL TYPES n Dry untreated logs with a maximum residual moisture content of 19% measuring 30 cm (max.) in length and approx. 10 cm in diameter. n Wood briquettes n Lignite briquettes FUEL QUANTITIES Quantity Logs Wood Briquettes Lignite Briquettes For 4 kW approx.: 1.0 kg/h 1.0 kg/h - Per stoke approx.: 0.8 kg 0.8 kg - For 8 kW approx.: 2.1 kg/h 2.1 kg/h 1.7 kg/h Per stoke approx.: 1.6 kg 1.6 kg 1.7 kg Depending on the quality of the fuel, the chimney and the weather conditions, it will take approx. 30-45 minutes for one stoking of fuel to burn down. When it has burned down to the red embers, the stove can be re-stoked. REGULATING THE AIR INFEED Air valves Secondary air (marked P) Open = slide knob at I Closed = slide knob at 0 Primary air (marked S) Open = slide knob at I Closed = slide knob at 0 DROOFF Kaminöfen — Feuer aus dem Sauerland
Page 1 and 2: elba INSTRUCTIONS FOR INSTALLATION
Page 3 and 4: INSTRUCTIONS FOR INSTALL ATION AND
Page 5 and 6: INSTALL ATION Seite 5 w w w. d r o
Page 7 and 8: INSTALL ATION Page 7 w w w. d r o o
Page 9 and 10: OPERATING INSTRUCTIONS Page 9 w w w
Page 11 and 12: OPERATING INSTRUCTIONS Page 11 w w
Page 17 and 18: DROOFF Kaminöfen — Feuer aus dem
Page 19: TECHNICAL INFORMATION Page 19 w w w
Page 23 and 24: TECHNICAL INFORMATION Page 23 w w w

INSTRUCTIONS FOR INSTALLATION AND OPERATION elba

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?