G1013 Manual - Grizzly Industrial Inc.

SECTION 7: MAINTENANCE
Disconnect power to the
machine when performing
any adjustments or
maintenance. Failure to
do this may result in serious
personal injury.
General
Lubrication
Your combination sander is equipped with shielded
and pre-lubricated ball bearings that require
no lubrication for the life of the bearings. All bearings
are common sizes and are readily available
from a local bearing supply house or our Service
Department. The roller shafts, however, will benefit
from regular applications of light machine oil.
See Figure 23.
Make a habit of inspecting your sander each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Worn or damaged V-belt.
5. Poor belt tensioning ⁄ tracking.
Table
Figure 23. Lubrication points.
The working table and other non-painted surfaces
on the Model G1013 should be protected
against rust and pitting. Wiping the sander clean
after every use ensures that sawdust is not
allowed to trap moisture against bare metal surfaces.
Tables can be kept rust-free with regular applications
of products like Boeshield ® T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit.
-20- G1013 Combination Sander