VRIOGS 012.2.1 - Public Transport Victoria
VRIOGS 012.2.1 - Public Transport Victoria
VRIOGS 012.2.1 - Public Transport Victoria
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
32 <strong>VRIOGS</strong> <strong>012.2.1</strong> REVISION A<br />
9.8 Transition between Cable Ladder/Cable Ladder/GST/GLT/Buried<br />
Route<br />
a) The transition between different cable ladder sizes shall be made using purpose<br />
built adaptors from the ladder manufacturer’s product range<br />
b) The transition between cable ladder and GST, GLT, pits or buried route including<br />
ULX and URX shall be made using purpose built adaptors fabricated from the same<br />
material as the cable ladder.<br />
c) The adaptor for ULX and URX shall be of sufficient size to accommodate all<br />
conduits from the ULX or URX, including spare conduits and shall extend from the<br />
cable route to within 300 mm of ground level.<br />
d) The void between the adaptor and the conduits shall be sealed.<br />
e) Modifications to the cable ladder to accommodate the adaptor shall not result in<br />
cables in the cable ladder being unsupported over lengths exceeding 600 mm.<br />
9.9 Cable Ladder Arrangements at Connection to Local Cable Route<br />
and Equipment<br />
a) The connection of the main cable ladder route to local cable route and equipment<br />
shall be made using purpose built tee pieces from the ladder manufacturer’s product<br />
range.<br />
9.10 Cable Ladder Covers<br />
a) Cable ladder covers are only required where the bottom of the cable ladder is less<br />
than 2.4 m above the adjacent rail level unless otherwise specified.<br />
b) Covers shall not be fitted until the cables have been inspected and approved.<br />
c) Cable ladder covers shall overlap the adjacent covers by a minimum of 20 mm<br />
(away from the direction of normal train movements) and shall be secured with<br />
stainless steel straps, one 100 mm from each end of each lid plus additional straps<br />
as required to ensure a maximum of 600 mm intervals between straps for 600 mm<br />
wide ladder and a maximum of 800 mm intervals between straps for other ladder<br />
widths.<br />
NOTE: This document is controlled only when viewed on the DOT Engineering Standards website.<br />
Any other copy of this document is uncontrolled, and the content may be inaccurate.