COMMUNICATION PROTOCOL E8-V5 - SIC-Venim s.r.o.
COMMUNICATION PROTOCOL E8-V5 - SIC-Venim s.r.o.
COMMUNICATION PROTOCOL E8-V5 - SIC-Venim s.r.o.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
•RUN<br />
start the marking<br />
Syntaxe :<br />
RUN <br />
Answer :<br />
RUN OK[CR][LF]<br />
[EOT]<br />
[ENQ]<br />
[NAK][Err1][Err2][Err3]<br />
start of marking<br />
last dot marked<br />
back to home position<br />
if an error occurse<br />
Data :<br />
Simulation (optonnal)<br />
Marking at force 0 if “Simulation”, else marking at normal force<br />
Erri if an error occurse, see fig 1 on annexe<br />
Note :<br />
If there is PAUSE in the marking file :<br />
At a PAUSE line, the control send the char P [0x50] and wait for :<br />
- response p [0x70] from RS232,<br />
- or the Start button to be pressed,<br />
to continue the marking,<br />
Example :<br />
Start marking<br />
String to send :<br />
RUN[LF]<br />
String received:<br />
RUN OK[CR][LF]<br />
start of marking<br />
[EOT]<br />
last dot marked<br />
[NAK][0x00][0x88][0x00] Error : 88 = 80 + 8 = Z axis + Error Sensor : Z axis is not at home<br />
position<br />
Start a simulation<br />
String to send :<br />
RUN SIMULATION[LF]<br />
String received:<br />
RUN OK[CR][LF]<br />
[EOT]<br />
[ENQ]<br />
start of marking<br />
last dot marked<br />
End of simulation OK<br />
• RESETERROR<br />
if an error occurse, you need to clear the machine status.<br />
Syntaxe :<br />
RESETERROR [CR][LF]<br />
Answer :<br />
RESETERROR OK[CR][LF]<br />
NOTPROTO<strong>E8</strong><strong>V5</strong>US – R02<br />
7/38
Change language