EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...

More documents

Recommendations

Info

The control panel, shown below, has a voltage selector switch and four receptacles. Receptacle 4, the 240-volt receptacle, has two powered terminals, 4A and 4B. EM5000SX: 4B 4A 120V 30A 120V 20A (in total) 120V 20A (in total) 4A & 4B 120/240V 30A Power Producing Circuits This generator is equipped with two power generating circuits. When the voltage selector switch is in the 120V/240V position, each of the two power producing circuits supplies power to specific receptacles. When the voltage selector switch is in the 120V ONLY position, the power producing circuits operate in parallel, sharing the total load connected to terminal 4A and receptacles 1, 2, and 3. 120V/240V 120V ONLY POWER CIRCUIT 1 POWER CIRCUIT 2 POWER CIRCUIT 1 POWER CIRCUIT 2 22
Voltage Selector Switch The power available to each receptacle depends on the position of the voltage selector switch. Switch Position 120V ONLY 120V/240V Receptacle 1 2 3 4A 4B 1 2 3 4A-4B Available Power 30A at 120V 20A at 120V 20A at 120V 30A at 120V None 18.8A at 120V 18.8A at 120V 18.8A at 120V 18.8A at 240V 120V ONLY Position When the voltage selector switch is in the 120V ONLY position, you do not need to spread the load over the receptacles. You must, however, make sure the load on any receptacle does not exceed its available power shown in the preceding table and the total load does not exceed 37.5 amps. 120V/240V Position When the voltage selector switch is in the 120V/240V position, you must balance the load. Divide the load between the two sets of receptacles shown below. Balancing is necessary because each set of receptacles is powered by only one power producing circuit that can produce a maximum of 18.8 amps. Set of Receptacles 134B 2 4A Total Current Available 18.8A 18.8A Power Producing Circuit 1 2 23
Page 1 and 2: EM3800SX•EM5000SX•EM6500SX See
Page 3 and 4: Congratulations on your selection o
Page 5 and 6: CONTENTS GENERATOR SAFETY .........
Page 7 and 8: GENERATOR SAFETY SAFETY LABEL LOCAT
Page 9 and 10: Electric Shock Hazards The generato
Page 11 and 12: TRANSPORT HANDLE FUEL TANK CAP FUEL
Page 13 and 14: Fuel Valve Lever The fuel valve is
Page 15 and 16: DC Terminals The DC terminals may O
Page 17 and 18: AC Circuit Breaker The AC circuit b
Page 19 and 20: GENERATOR USE Connections to a Buil
Page 21 and 22: AC Operation 1. Start the engine (s
Page 23: Voltage Selector Switch The power a
Page 27 and 28: Voltage Selector Switch The power a
Page 29 and 30: An overloaded DC circuit, excessive
Page 31 and 32: High Altitude Operation At high alt
Page 33 and 34: Refueling With the engine stopped,
Page 35 and 36: STARTING THE ENGINE/STOPPING THE EN
Page 37 and 38: MAINTENANCE The Importance of Maint
Page 39 and 40: Maintenance Schedule REGULAR SERVIC
Page 41 and 42: Air Cleaner Service A dirty air cle
Page 43 and 44: Spark Plug Service In order to serv
Page 45 and 46: Fuse Replacement If the fuse is blo
Page 47 and 48: Service according to the table belo
Page 49 and 50: Engine Oil 1. Change the engine oil
Page 51 and 52: TRANSPORTING When transporting the
Page 53 and 54: No electricity at the AC receptacle
Page 55 and 56: Problems That May Affect Emissions
Page 57 and 58: WIRING DIAGRAM EM3800SX 55
Page 59 and 60: SPECIFICATIONS Dimensions Model Typ
Page 61 and 62: Dimensions Model Type Description c
Page 63 and 64: Important Safety Precautions Make s
Page 65 and 66: Handle Installation Install the rig
Page 67 and 68: Hanger Kit Installation (optional)
Page 69 and 70: Remote Control Box PILOT LAMP START
Page 71 and 72: CABLE TIE STARTER SOLENOID STARTER
Page 73 and 74: BEFORE OPERATION Before using your
Page 75 and 76:
Honda PUBLICATIONS Shop Manual This
Page 77 and 78:
PRE-OPERATION CHECK ...............
Page 79:
00X31-Z21-6050 K2:EM5000SX
show all

EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

EM3800SXâ¢EM5000SXâ¢EM6500SX - Geotech Environmental ...