Installation Guide - Dana Corporation
Installation Guide - Dana Corporation
Installation Guide - Dana Corporation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Installation</strong><br />
Axle Hose <strong>Installation</strong><br />
1. In the left 1/4" pipe hole located on the top of the axle<br />
tube, route the small covered end of the metal<br />
braided hose into the axle.<br />
Note: Make sure that the braided hose heads toward the spindle<br />
end.<br />
2. Making sure that the hose is going toward the correct<br />
wheel end, continue feeding the metallic covered<br />
hose into the trailer axle until the small end of the<br />
hose exits the spindle end.<br />
3. Thread the large adapter end of the axle hose assembly<br />
into the axle and tighten to 20 lbs. ft. (27.1 N•m).<br />
4. Remove protective coverings from end of the axle<br />
hose assembly and blow air through it to remove any<br />
debris.<br />
5. Repeat steps 1 through 4 for the opposite side of the<br />
axle.<br />
Hose Routing in Axle<br />
Route<br />
Braided Hose<br />
Into Axle<br />
Route<br />
Braided Hose<br />
Into Axle<br />
D22-Style<br />
Spindle<br />
OR<br />
P22-Style<br />
Spindle<br />
218UX009<br />
Thread Adapter<br />
Into Axle<br />
Thread Adapter<br />
Into Axle<br />
D22-Style<br />
Spindle<br />
OR<br />
P22-Style<br />
Spindle<br />
218UX010<br />
11