owner's manual - Hydropool
owner's manual - Hydropool
owner's manual - Hydropool
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
LEVELING YOUR HYDROPOOL Swim Spa<br />
After the swim spa is properly positioned on the support<br />
base, the entire unit should be checked and leveled as<br />
necessary. Should you find that the unit is sloped or the base is<br />
otherwise uneven, level your swim spa using a 2”– 3” clear<br />
sand bed. Make sure to enclose or ‘box-in‘ the sand to prevent<br />
erosion. This will ensure contact with the entire support<br />
base to appropriately distribute the weight of the swim spa<br />
structure. Do not just shim under the outside edge, as<br />
this will cause structural stress on the unit, potentially<br />
causing damage to the swim spa structure.<br />
SET-UP & Assembly<br />
Set-up of your swim spa will vary depending on whether you have purchased an Aquatrainer, Aquaplay, or Aquasport<br />
model. Once your swim spa is set into place, you are ready to install the steel support legs and connect the equipment<br />
package.<br />
Steel Support Leg Assembly<br />
Do not tighten or adjust steel support legs until water is added to the swim spa. Refer to Filling, Checking and<br />
Starting Your Swim Spa for final adjustment(s).<br />
Steel Support Leg Assembly Overview<br />
14’ unit = 9 legs<br />
17’ unit = 11 legs<br />
1<br />
1 Threaded post - protrudes below swim spa lip<br />
2 Foot Assembly - includes foot plate & two<br />
hex nuts<br />
3 Hex Nut Assembly<br />
4 Square support leg<br />
3<br />
4<br />
2<br />
11
Change language