owner's manual - Hydropool

REMOTE Equipment
REMOTE EQUIPMENT placement
• The equipment should be located as close to the swim
spa as possible to maximize jet performance
• Whenever possible, install the pump(s) and control
with heater below water level to ensure easy priming
and maximize performance. Where above-grade
equipment location is necessary, ensure that your
swim spa is equipped with the optional REMOTE
ABOVE-GRADE EQUIPMENT PACKAGE.
• The distance of the swim spa support equipment from
the unit should never exceed 3m (10 ft.) of pipe length,
otherwise jet performance will be affected.
• Piping diameter on pump lines must be 2.5 in. for inlet/
suction pipes and 2 in. for outlet/pressure pipes with
minimal use of elbows.
• Install protective waterproof conduit to house
applicable cords or line extensions such as the topside
control cables, light wires or ozone tubing.
• In climates where freeze/thaw occurs we recommend that
remote plumbing lines be buried below the frost line and
that pipe insulation is applied over all pipes that run from
the swim spa to the remote equipment to help maintain
energy efficiency.
• The swim spa equipment is designed for indoor/out
of the direct elements use. Your custom enclosure
or other structure must be designed to provide
protection for the swim spa support equipment from
rain, snow, splash water, etc., but still designed in a
manner to ensure adequate ventilation.
above-Grade EQUIPMENT Placement
(Aquaplay North America Only)
In the event that you are plumbing your equipment in
a remote location where the support equipment will be
higher than the swim spa fill water level, you should have
purchased the optional REMOTE ABOVE-GRADE EQUIPMENT
PACKAGE consisting of:
1 Self-priming pumps with strainer basket
2 Topside control panel extension
3 Light niche and extension
It is the responsibility of the installer to provide any
additional pipe or plumbing fittings that may be required.
• The equipment should not be located further than 3m
(10 ft.) from the swim jets, and must be placed in a dry,
vented area, easily accessible for service.
• The equipment should not be installed more than
30 cm (12 in.) higher than the swim spa fill water level.
• All field installed plumbing must meet minimum sizes
as previously outlined in order to conform to regulated
standards regarding safe inlet and outlet flows. If required,
please call your dealer for more detailed drawings.
Remote Equipment Plumbing Diagrams
Inlet/Suction Side Plumbing Connections
Outlet/Pressure Side Plumbing Connections
Pump 1 Pump 1
P3
P1
P2
2 1/2" Dia.
2" Dia.
P3
P1
P2
Pump 2 & 3 Pump 2 & 3
P3
P1
P2
2 1/2" Dia.
2" Dia.
P3
P1
P2
9