DALI manual - Tridonic

More documents

Recommendations

Info

. c Annex Annex Technical features of a DALI circuit Maximum no. of DALI units: 64 Maximum no. of DALI groups: 16 Maximum no. of DALI scenes:16 DALI voltage: 9.5 V – 22.5 V, typically 16 V DALI system current: Max. 250 mA (depending on the installed DALI power supply) Data transfer rate: 1200 baud Maximum cable length: The maximum cable length depends on the maximum permitted voltage drop along the DALI cable; this is defined as 2 V max. This corresponds to a maximum cable length of 300 m for a line cross-section of 1.5 mm². ½ CAUTION! When calculating the maximum cable length the contact resistance must also be taken into account. A voltage drop of 2V must not be exceeded. ... DALI Manual | 08-2013 | en 86 / 93
. c Annex Important DALI parameters and DALI commands Table: Important DALI ballast parameters DALI parameter Actual Level Maximum Level Minimum Level Power ON Level System Failure Level Fade Time Fade Rate Scene registers 1-16 Group register Description Current brightness value of the ballast Maximum brightness value – this value cannot be exceeded when fading up Minimum brightness value – this value cannot be undershot when fading down Brightness value to which the DALI ballast switches when the power supply is switched on. Brightness value to which the DALI ballast switches when a fault is detected in the DALI circuit (e.g. interruption or short-circuit on the DALI line) Time in seconds for fading from the current brightness value to the new brightness value (for DAP commands and scene calls) Fade steps per second that are performed in response to an indirect fade command (Up and Down commands) These registers are where the brightness values for the individual scenes are stored. This register is where the group assignment of the DALI ballast is stored. DALI Manual | 08-2013 | en 87 / 93
Page 1 and 2:
luxCONTROL DALI manual
Page 3 and 4:
. c Table of contents Table of cont
Page 5 and 6:
. c Introduction: DALI standard Fea
Page 7 and 8:
. c Introduction: DALI standard Pos
Page 9 and 10:
. c DALI controllers of comfortDIM
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
. c DALI devices DALI devices Elect
Page 17 and 18:
. c DALI devices Electronic HID con
Page 19 and 20:
. c DALI devices EM powerLED PRO EZ
Page 21 and 22:
. c comfortDIM product series in de
Page 23 and 24:
. c DALI group controllers: DALI GC
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
. c DALI scene controllers: DALI-SC
Page 33 and 34:
. c DALI scene controllers: DALI-SC
Page 35 and 36: . c DALI multi controller: DALI MC
Page 43 and 44: . c DALI TOUCHPANEL 02 Connection T
Page 45 and 46: . c DALI TOUCHPANEL 02 Figure: Over
Page 47 and 48: . c DALI x/e-touchPANEL 02 x-touch
Page 49 and 50: . c DALI x/e-touchPANEL 02 Emergenc
Page 51 and 52: . c DALI sequencer module: DALI SQM
Page 53 and 54: . c DALI MSensor 02 DALI MSensor 02
Page 55 and 56: . c DALI MSensor 02 Table: Grouping
Page 57 and 58: . c DALI USB DALI USB The DALI USB
Page 59 and 60: . c Designing a DALI application Ma
Page 61 and 62: . c Designing a DALI application Wi
Page 63 and 64: . c Designing a DALI application Sa
Page 65 and 66: . c Designing a DALI application Ta
Page 67 and 68: . c Designing a DALI application Op
Page 69 and 70: . c Designing a DALI application Ta
Page 71 and 72: . c Start-up Sample set-up for a co
Page 73 and 74: . c Start-up Installation The DALI
Page 75 and 76: . c Start-up Figure: Installing a D
Page 77 and 78: . c Start-up Setting up with master
Page 79 and 80: . c Start-up Step 3: Testing the ad
Page 81 and 82: . c Maintenance and troubleshooting
Page 83 and 84: . c Maintenance and troubleshooting
Page 85: . c Maintenance and troubleshooting
Page 89 and 90: . c Annex Current draw of the comfo
Page 91 and 92: . c Annex DALI MSensor 02 broadcast
Page 93: . c Reference list Reference list R
show all

DALI manual - Tridonic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?