INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>MIL</strong>-<strong>PRF</strong>-<strong>13830B</strong><br />
APPENDIX C<br />
C.3.8.5 Adhesion. The coated optical surface shall show no evidence of coating<br />
removal when cellophane tape is pressed firmly against the coated surface and<br />
quickly removed at an angle normal to the coated surface.<br />
C.4. VERIFICATION<br />
C.4.1 General provisions. Unless otherwise specified in the contract or purchase<br />
order, the supplier is responsible for the performance of all inspection requirements<br />
as specified herein. Except as otherwise specified, the supplier may utilize his own<br />
facilities or any other facilities suitable for the performance of the inspection<br />
requirements specified herein, unless disapproved by the Government. The<br />
Government reserves the right to perform any of the inspections set forth in the<br />
specification where such inspections are deemed necessary to assure that supplies<br />
and services conform to prescribed requirements (See C.6.2).<br />
C.4.1.1 Witness piece. Unless otherwise specified, witness pieces as defined in<br />
C.4.1.2 or coated components may be used to test the optical and durability<br />
requirements of the coated component (See C.4.2, C.4.3 and C.6.2). The witness<br />
pieces shall be positioned in the coating chamber such that they represent the optical<br />
and durability characteristics of the whole evaporated lot (See C.6.3). The<br />
Government reserves the right to test the actual coated component with the same<br />
test to which the witness pieces were subjected, except in the case where the known<br />
Knoop hardness of the coated component is less than 450 kg/mmì, the moderate<br />
abrasion test of C.4.5.11 shall be utilized. Should a component fail, even through the<br />
representative witness pieces pass the test, the lot shall be rejected.<br />
C.4.1.2 Characteristics of the witness piece. When the witness pieces are used to<br />
test the optical and durability requirements of the coated component they shall<br />
exhibit the following characteristics:<br />
a. The witness piece shall be such that it presents no difficulty in<br />
measuring and testing the optical and durability requirements of the<br />
coating.<br />
b. The witness piece shall have a surface finish similar to that of the<br />
component to be coated.<br />
c. The witness piece shall simulate the axial thickness of the component<br />
by either computational methods or using a witness piece that has<br />
the same thickness as the coated component for the measurement of<br />
transmission characteristics.<br />
43<br />
Source: http://www.assistdocs.com -- Downloaded: 2006-05-24T15:32Z<br />
Check the source to verify that this is the current version before use.