INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
INCH-POUND MIL-PRF-13830B 9 January 1997 SUPERSEDING ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>MIL</strong>-<strong>PRF</strong>-<strong>13830B</strong><br />
APPENDIX E<br />
ASTM D471 - Rubber Property - Effect of Liquids<br />
ASTM D897 - Tensile Properties of Adhesive Bonds<br />
ASTM D4397- Polyethylene Sheeting for Construction Industrial,<br />
and Agricultural Applications<br />
ASTM E437 - Industrial Wire Cloth and Screens (Square Opening<br />
Series)<br />
ASTM D 4802- Poly(Methyl Methacrylate) Acrylic Plastic Sheet<br />
(Application for copies should be addressed to American Society for Testing and<br />
Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.) (See<br />
contract provisions for additional precedence criteria).<br />
E.2.3 Order of precedence. In the event of a conflict between the text of this<br />
document and the references cited herein, the text of this document takes<br />
precedence. Nothing in this document, however, supersedes applicable laws and<br />
regulations unless a specific exemption has been obtained. (See contract provisions<br />
for additional precedence criteria).<br />
E.3. REQUIREMENTS<br />
E.3.1 Material.<br />
E.3.1.1 Sealing compound. Sealing compound should be a non-curing mastic<br />
organic polysulfide polymer. The sealing compound shall be homogeneous, stable,<br />
and noncorrosive.<br />
E.3.2 Volatile content. The volatile content of sealing compound shall be not<br />
greater than 1.5 percent when tested as specified in E.4.5.1.<br />
E.3.3 Water solubility. The water solubility of the sealing compound shall be not<br />
greater than 0.4 percent when tested as specified E.4.5.2.<br />
E.3.4 Oil resistance. Sealing compound shall show no evidence of blistering,<br />
softening, or loss of adhesion when exposed to mineral oil and tested as specified in<br />
E.4.5.3.<br />
E.3.5 Adhesion. Sealing compound shall have a bond strength of not less than<br />
25 psi (1.75 kg/cm). Failure shall occur only in the sealing material itself when<br />
tested as specified in E.4.5.4.<br />
E.3.6 Aging. When tested as specified in E.4.5.5, the sealing compound shall<br />
69<br />
Source: http://www.assistdocs.com -- Downloaded: 2006-05-24T15:32Z<br />
Check the source to verify that this is the current version before use.
Change language