NXT Controller Manual IP Assignment in WAN ... - Keri Systems
NXT Controller Manual IP Assignment in WAN ... - Keri Systems
NXT Controller Manual IP Assignment in WAN ... - Keri Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>NXT</strong> <strong>Controller</strong> <strong>Manual</strong> <strong>IP</strong> <strong>Assignment</strong> <strong>in</strong> <strong>WAN</strong> Environments<br />
Application Note<br />
Ethernet RJ-45 Connection<br />
Reset LED<br />
TB9<br />
<strong>NXT</strong> <strong>Controller</strong><br />
1<br />
2<br />
3<br />
4<br />
J2<br />
S1<br />
J3<br />
10/100 (D21)<br />
Activity (D33)<br />
L<strong>in</strong>k (D22)<br />
3. Cycle power on the controller. Try the p<strong>in</strong>g command aga<strong>in</strong>.<br />
4. Reset the controller. This will restore the controller to a factory default state, restor<strong>in</strong>g the factory<br />
default <strong>IP</strong> address. Try the p<strong>in</strong>g command aga<strong>in</strong>.<br />
Perform the follow<strong>in</strong>g to reset a controller:<br />
• Remove power from the <strong>NXT</strong> controller.<br />
• Install a Jumper across the J3 p<strong>in</strong> header.<br />
• Press the S1 switch and hold it down while apply<strong>in</strong>g power. Keep the button pressed until the<br />
Reset LED (D48) comes lit. This <strong>in</strong>dicates the reset rout<strong>in</strong>e has begun.<br />
• DO NOT REMOVE POWER FROM THE <strong>NXT</strong> CONTROLLER <br />
WHILE THE RESET LED IS LIT.<br />
• The Reset is complete when the Reset LED goes dark.<br />
• Cycle power on the controller.<br />
If these steps do not resolve your communication issues your setup requires more detailed<br />
troubleshoot<strong>in</strong>g that cannot be covered <strong>in</strong> this document.<br />
Page 6 of 25<br />
P/N: 01564-001 Rev. A
Change language