The Gas Analyzer - ADInstruments

More documents

Recommendations

Info

E Specifications A P P E N D I X Specifications Sampling system: <strong>Gas</strong>es: System sampling flow rate: Internal damping volume: <strong>Gas</strong> connector: One CO 2 and one O 2 transducer fed from a damped, micro-vacuum pump. Must be non-corrosive and nonflammable. A moisture removal scheme must be employed before the sampling inlet. Approximately 35–200 ml/min (user variable). 75 ml Plastic Luer Moisture filter: It is recommended that a 0.45 µm hydrophobic membrane filter be fitted before the sampling inlet. Tubing material: Tygon TM Materials in contact with gas: 316 stainless steel, phosphor bronze (Grade C52100), sapphire, Epotek H72 adhesive, Nylon 66, Tygon TM Warm-up time: 10 min @ 20 °C Appendix E Specifications 29
CO 2 System Type: Infrared, optical Range: 0–10% CO 2 Output: Linear, 0–1 V (0–10% CO 2 ) Resolution: 0.1% CO 2 Linearity: ±0.1% CO 2 Initial drift:
Page 1: Gas Analyzer Owner’s Guide
Page 5 and 6: This document was, as far as possib
Page 7 and 8: B Troubleshooting31 C Specification
Page 9 and 10: Safety Symbols Devices manufactured
Page 11 and 12: Always check the status indicator o
Page 13 and 14: •• Additional multiple portable
Page 15 and 16: 12 STH Pump Controller Owner’s Gu
Page 17 and 18: How to Use This Guide This owner’
Page 19 and 20: Exhaust Port A single exhaust port
Page 21 and 22: Connecting the Gas Analyzer The Gas
Page 23 and 24: is a reusable length of reinforced
Page 25 and 26: Default Calibration Settings Both t
Page 28 and 29: 3 Care C H A P T E R and Maintenanc
Page 30 and 31: A P P E N D I X DTroubleshooting Th
Page 34 and 35: Operating Requirements Power supply
Page 36 and 37: A P P E N D I X A Technical Details
Page 38 and 39: Considerations When Using the Gas A
Page 40 and 41: Warranty Product Purchase and Licen
Page 42 and 43: able to do so. Copies of applicable
Page 44 and 45: CHARACTER INCLUDING, WITHOUT LIMITA
Page 46 and 47: Index A analog outputs 16 B back pa

The Gas Analyzer - ADInstruments

Create successful ePaper yourself

Delete template?

Save as template?