HD Color Video Camera â EVI-H100S/H100V A - Full Compass
HD Color Video Camera â EVI-H100S/H100V A - Full Compass
HD Color Video Camera â EVI-H100S/H100V A - Full Compass
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
D70 Mode<br />
Overview<br />
The D70 mode allows you to control the <strong>EVI</strong>-<strong>H100S</strong>/<br />
<strong>H100V</strong> using VISCA commands for the <strong>EVI</strong>-D70/P.<br />
Most of the VISCA commands for the <strong>EVI</strong>-<strong>H100S</strong>/<br />
<strong>H100V</strong> correspond to one for the <strong>EVI</strong>-D70/P. However,<br />
some of the VISCA commands for the <strong>EVI</strong>-<strong>H100S</strong>/<br />
<strong>H100V</strong> are different from those for the <strong>EVI</strong>-D70/P in<br />
definitions of parameters.<br />
When you send those commands to an <strong>EVI</strong>-<strong>H100S</strong>/<br />
<strong>H100V</strong> whose D70 mode is set to ON, the camera<br />
translates the parameters for the <strong>EVI</strong>-D70/P to those<br />
for the <strong>EVI</strong>-<strong>H100S</strong>/<strong>H100V</strong> and executes the command.<br />
The following parameters are subject to translation.<br />
Zoom position<br />
Pan-tilt speed<br />
Pan-tilt position<br />
Notes<br />
Even if you set the D70 mode to ON, the <strong>EVI</strong>-<br />
<strong>H100S</strong>/<strong>H100V</strong> may not emulate the <strong>EVI</strong>-D70/P<br />
perfectly. This is caused by differences in hardware<br />
between the two models.<br />
The functions that are provided with the <strong>EVI</strong>-D70/<br />
P but not with the <strong>EVI</strong>-<strong>H100S</strong>/<strong>H100V</strong> cannot be<br />
executed.<br />
Switching the Mode<br />
You can switch the D70 mode ON or OFF by switching<br />
the BOTTOM switch at the bottom of the <strong>EVI</strong>-<strong>H100S</strong>/<br />
<strong>H100V</strong>. To change the D70 mode setting, move the<br />
BOTTOM switch to ON or OFF while the camera’s<br />
power is off or the camera is in standby mode. Then,<br />
turn the power on by connecting the camera to an AC<br />
outlet or by using the VISCA commands or the Remote<br />
Commander.<br />
It takes about 7-16 seconds for the image to be<br />
displayed after Pan/Tilt initialization motion has<br />
stopped.<br />
Do not turn off DC power until the image has been<br />
displayed.<br />
The mode will not change if you change the switch<br />
setting of the BOTTOM switch after the power has<br />
been turned on.<br />
After you change the mode, previously saved position<br />
preset data will be lost. (Zoom, Pan/Tilt positions, etc.<br />
will be reset to their initial settings.)<br />
47