INSTALLATION AND OPERATION MANUAL - Wood Pellet Stoves
INSTALLATION AND OPERATION MANUAL - Wood Pellet Stoves
INSTALLATION AND OPERATION MANUAL - Wood Pellet Stoves
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>INSTALLATION</strong><br />
INSTALLING ADVANTAGE II-T C INS (CONTINUED)<br />
Full Chimney Reline<br />
Recommended for All Chimney Installations<br />
Seal Chimney top with steel<br />
plate and/or pipe support<br />
Approved Liner for Factory<br />
Built (ZC) Fireplaces and<br />
Masonry Fireplaces is<br />
2100HT (degree F.) liner<br />
listed to UL 1777 or ULC<br />
S635. The liner must be securely<br />
attached to the insert<br />
flue collar and the chimney<br />
top.<br />
1” Min.<br />
(25 mm)<br />
to Trim<br />
Mantel<br />
♦ 6” Min. Floor<br />
Protection<br />
18” Min.<br />
(457 mm)<br />
to Mantel<br />
Listed Rain Cap<br />
Optional Positive<br />
Flue<br />
Connection<br />
♦ USA & Canada – Requires an approved noncombustible<br />
hearth or floor protector, 3/8” / (10 mm)<br />
millboard or equivalent (k = .84, r = 1.19) to extend<br />
6” / 150 m19-20m to the front of the glass<br />
door.<br />
IMPORTANT NOTES:<br />
Clean<br />
Out Tee ♦ 6” Min. Floor<br />
Protection<br />
PAGE 20<br />
Horizontal Vent Through Masonry Chimney Structure<br />
A flexible corrugated chimney<br />
liner has much greater resistance<br />
to the flow of flue gases<br />
than does a rigid liner. For this<br />
reason we recommend that a<br />
larger, 4” liner be used on vertical<br />
runs exceeding 15 feet or<br />
that rigid venting be used as<br />
illustrated on this page (see<br />
Full Chimney Reline).<br />
If a flexible corrugated chimney<br />
liner is used, it must be fully<br />
extended to eliminate any sagging<br />
and to improve the exhaust<br />
flow.<br />
.<br />
Mantel<br />
18” Min.<br />
(457 mm)<br />
to Mantel<br />
www.<strong>Pellet</strong>King.com<br />
IN CANADA – Installing as a Horizontal<br />
Vent is NOT allowed. The fireplace<br />
chimney must be fully lined.<br />
1” Min.<br />
(25 mm)<br />
to Trim<br />
USA – The insert may<br />
be installed as a Horizontal<br />
Vent (through<br />
chimney structure) in<br />
Masonry Fireplaces if<br />
local code permits.<br />
� Do not block opening at front of insert (below<br />
door).