Download - Mega Miniatures

I think it should
be might really
not be worth of a
discussion. I'd
like to see some
fantasy football
models that are
not carrying the
football. We need
guys to do the
smashing and hitting
too.
at least that's how I remember it. Also, the guns on both models
are the same size which is a nice bit of proper continuity between
the models. There was also some cleaning needed on the
big guy, but not as much as on the smaller one. The arms fit
onto the body up at the shoulders and don't leave much
poseability unless you want to break out the green stuff. I'll pass
on any conversions as I think he looks fine as is. Outside of
Infinity the larger model could be used as a player character in
Feng-Shui or Traveller20.
Name: 280113-0058 Ariadna Para-Commando
MSRP: 7.00€
Reviews by Mark Theurer
Name: 280112-0054 Dog Warrior & Dogface
MSRP: 16.00€
Oh yeah, more big dogs for my Ariadna army! In this blister
you get two figures, each of them coming in three pieces. The
set represents the two physical phases of one soldier. The Dogface
is the regular or "human" version of the model and he's
carrying two chain rifles and wears a long hooded robe and a
pair of oversized jeans and bare feet. There were several bits of
flash and small metal burrs on the model that needed to be
cleaned before he could be assembled, but the mold line was
undetectable. He has a long ponytail draped over his chest and a
very stern look on his face. Once assembled he sits on a standard
round slotta-base. The second model is much larger and
represents a transformation that the Dogface undergoes after
being injured. He becomes a Dog Warrior and bulks up considerably,
almost to the size of an ogre. Basically, it's a very large
werewolf that's carrying two guns that would normally be
suited to being carried in two hands by a normal sized model,
but are definitely one-handers for the super-sized guy. Upon
transformation he discards his cloak and shows off a muscled
bare chest and you also get a look at a few pouches, a grenade
and a knife on his belt. His jeans have now become skin tight
and I like that the sculptor took this into account on both models.
The jeans are too loose on one model and too tight on the
other. It's not like in the Hulk comics that I read as a kid where
Dr. Banner's pants would still fit just fine regardless of his size,
51
This three-piece model depicts a paratrooper that has recently
hit the ground and is getting ready to get into the fight. The
main model is hunched over and is dragging his parachute and
gear (the left arm and gear is a separate piece) while he carries a
grenade launcher (also a separate piece) in his right hand. The
model comes with two bases, a standard 25mm round base and
a larger 40mm round base. The larger base has adequate room
for the miniature and his parachute/gear but puts the figure on a
larger base than is intended for a model his size. The smaller
base can also be used but the parachute/gear will hang off the
edge of the base. I’ll be mounting mine on the larger base and
just have to remind myself, and my opponent’s, of how we need
to consider his base size during the game. He’s not wearing a
lot of armor but does carry quite a bit of gear including a
breathing mask, a knife and lots of pouches. It did have more
flash than a lot of other Infinity models and did need some
more cleaning before it was ready to assemble, but I found no
visible mold line anywhere on the model. In game terms the
Para-Commandoes wear camouflage that gives their opponent's
a –3 modifier to shoot them and they have a huge freedom of
deployment on the board, as their name would apply. I’ll definitely
be adding more of these to my Ariadna army, but I would
love to see another model for this troop type that matches the
female paratrooper in the rulebook.
Name: 280411-0057 Hassassin Ragiks (HMG & Rifle)
MSRP: 12.00€
Haqqislam gets some jump-capable troops to move around the
battlefield with some more ease than regular troops with the
Hassassin Ragiks. Each of the two models in this blister comes
with at least five parts that go into the complete model. Two of
the parts are small jet turbines and wings that fit easily into
grooves on their backs, but they will need to be carefully removed
from the metal sprue that they are cast on. One guy
cradles a heavy machinegun in two hands while the other car-