Download - Mega Miniatures

Name: 060601 Terri the Seampunk Cowgirl
Sculptor: Patrick Keith
MSRP: $ 4.99
Terri the Steampunk Cowgirl
is a multi-piece model
that can be assembled to
carry either a pistol or a
spear. She's done in with a
very steampunk, as her
name would imply, look
with a steam pack on her
back and what looks like a
plate (with steam vents)
bra. One hot chick! :) She
also has a separate pair of
smoke/steam vents that fit
onto the top of the steampack
on her back. The hat
looked a bit small at first glance but it's more that she has a lot
of hair flowing out from under it. There are a few bags on her
belt and a few metal plates on her pants, but overall she's not
wearing much armor.
The mold line was visible around most of the figure but was not
thick at all and cleaned up quickly. The weapons and vents
come on a separate sprue and need to be clipped of before assembly
and cleaning for the pieces was about the same as with
the bulk of the figure.
Dredd comics. Her jacket is also covered in pockets and has
padded shoulders. The hair is really well done and has very
thin individual strands that are visible. Detail on the whole
figure is clean and well done.
There were a couple, actually three, very small bits of flash that
needed to be removed from the model and
the mold line was faintly visible along her
arms and on the inside of her legs. Cleaning
took just about a minute and she was ready
to be based and primed. I successfully bent
the right hand, carrying the gun, a bit more
inwards to make it look more like she was
looking at the same place that she's pointing
the gun. If you want to do the same just be
careful not to mess with it too much and
weaken the model.
I like the figure a lot and will be dropping
her into my APAC army for Rezolution.
She could also do very well in a Ronin army
or in just about any modern or sci-fi game.
Name: 060801 Hesperus the Black Widow
Sculptor: Patrick Keith
MSRP: $ 14.99
The figure's pose has her left hand extended as if she's casting a
spell or maybe commanding someone to halt before she fires.
It's a nice figure that has definite applicability in steampunktype
games. If she is armed with the pistol she would make an
excellent Gun Mage character in an Iron Kingdoms D&D game
or even the leader of a unit of Gun Mages in Warmachine.
Armed with the spear I think she would do very well as a Journeyman
Warcaster, also in a Cygnar army.
Name: 060701 Trixi the Galactic Repo Agent
Sculptor: Patrick Keith
MSRP: $ 4.99
Trixie is a single-piece
model that is carrying a
grenade in one hand and
a large pistol in the other.
She definitely has a
spunky look to her with
her hair in pig-tails and
wearing a shirt/jacket
combo that shows off her
midriff. She wears tight
pants with several pockets
and a large belt and
big boots that are slightly
reminiscent of those that
are stylish in the Judge
67
This is one heck of a model, and if you ask me, you are getting
a whole lot of model for you money. This tough looking lady
stands over two inches tall and covers roughly
a three inch square area (some variation depending
on how you assemble the legs). She
comes in a total of fourteen pieces, so there is
a little work in assembling her. Eight of the
pieces are her individual legs, and they come
mounted on sprues. Each sprue has four legs
on it, and the four are slightly different in
length and angle. Her sizable abdomen (her
rear section) comes in two large halves accounting
for two more of the pieces. The
remaining pieces are her Thorax (mid section
where six of the legs attach) her long spear
(with both of her hands attached), most of the
human part of her, and finally her left arm.
Besides the sprues, and a post that attaches
the thorax and left arm pieces, there is sur-