Sun Fire X4100 and Sun Fire X4200 Installation Guide

More documents

Recommendations

Info

30 Sun Fire X4100 and Sun Fire X4200 Installation Guide • October 2006
CHAPTER 3 Configuring the Pre-installed Solaris 10 Operating System This chapter explains the steps for configuring the Solaris 10 Operating System (OS) that has been pre-installed on your server. The factory-installed version is Solaris 10 6/06 or later. Note – Unlike with SPARC ® systems, you will not see the output of the preinstalled Solaris 10 image through a monitor when you power on the server. The output of the pre-installed image is directed to a serial console instead of a monitor that is attached to the server. Before You Begin Before you begin configuring the pre-installed OS, you need to do the following: 1. Perform initial configuration of the server’s Integrated Lights Out Manager (ILOM) Service Processor (SP) and determine the server’s network settings, as described in “Connecting to the ILOM Service Processor” on page 21. 2. Gather the information that you will need for the configuration, as listed in “Installation Worksheet” on page 31. Installation Worksheet Use the worksheet in TABLE 1 to gather the information that you need to configure the pre-installed Solaris 10 OS. You only need to collect the information that applies to your application of the system. 31
Page 1 and 2: Sun Fire X4100 and Sun Fire X4200
Page 3 and 4: Contents Preface v 1. Setting Up th
Page 5 and 6: Preface This Sun Fire X4100 and Sun
Page 7 and 8: Typographic Conventions Typeface *
Page 9 and 10: 1 Setting Up the Server Hardware CH
Page 11 and 12: Disassembling the Slide-Rails Befor
Page 13 and 14: Attaching the Slide-Rail Assemblies
Page 15 and 16: 4. Simultaneously pull and hold the
Page 17 and 18: Right slide-rail CMA mounting brack
Page 19 and 20: CMA cable hanger CMA arm FIGURE 1-1
Page 21 and 22: Cabling Attach cables to the back p
Page 23 and 24: Powering On and Powering Off the Se
Page 25 and 26: ■ Emergency shutdown: Press and h
Page 27 and 28: CHAPTER 2 Setting Up the Server Sof
Page 29 and 30: Connecting to the ILOM Service Proc
Page 31 and 32: Connecting to ILOM Using an Etherne
Page 33 and 34: FIGURE 2-2 Opening a Session With a
Page 35 and 36: FIGURE 2-4 Integrated Lights Out Ma
Page 37: Setting Up Platform Operating Syste
Page 41 and 42: TABLE 1 Worksheet for Installation
Page 43 and 44: Configuring the Pre-Installed Solar
Page 45 and 46: The screens that are displayed will
Page 47 and 48: Solaris 10 User Documentation You c
Page 49 and 50: Index B back panel cable connectors

Sun Fire X4100 and Sun Fire X4200 Installation Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?