1967 Chevy Sedan-Impala - Classic Auto Air

More documents

Recommendations

Info

YOU CAN NOW BEGIN THE INSTALLATION Remove Glove box door, glove box, retain glove box and original hardware. Remove radio, set aside for reinstall. Retain original hardware. Remove screws from the fresh air door control bracket. Retain original hardware. Let cable assembly drop the floor. Disconnect battery and remove. Remove the hood. Retain original hardware. The bolts for the inner fender liner must be removed and retained. Remove the passenger’s front wheel. BOLTS INNER FENDER BOLTS AROUND WHEEL OPENING. BOLTS ON TOP OF FENDER LINER 4
Carefully remove the following components as shown in the pictures below. Retain all components and original hardware. LIGHT BEZEL TURN SIGNAL ASSEMBLY CORNER BUMPER ASSEMBLY Remove the corner bumper assembly. The bolts are located as shown in the picture. BOLTS The body trim needs to be removed along the lower side as shown. BODY TRIM Carefully snap off the trim. Caution: do not scratch paint. 5
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3: specializing in “AIR CONDITIONING
Page 7 and 8: Remove fender and set aside for lat
Page 9 and 10: Remove the (4) screws along the top
Page 11 and 12: Attach Wire Harness supplied in kit
Page 13 and 14: Locate the evaporator, (1) 1ft of 2
Page 15 and 16: Route the heater hoses that were at
Page 17 and 18: Locate 6” piece of drain tube. Ju
Page 19 and 20: Locate the Condenser, (2) right con
Page 21 and 22: INSTALL THE COMPRESSOR ADAPTER KIT
Page 23: IMPORTANT CAUTION: WATER VALVE MUST

1967 Chevy Sedan-Impala - Classic Auto Air

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?