GTO/PRO GP-SW100 - Gate Openers | Access Controls
GTO/PRO GP-SW100 - Gate Openers | Access Controls
GTO/PRO GP-SW100 - Gate Openers | Access Controls
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Overview of a Dual <strong>Gate</strong> Operator Installation<br />
The diagram below is an example of a dual swing gate installation with required safety features. The operators must be installed on the inside of<br />
the gate. You must install safety edges and photo beams (not included) to reduce the possibility of bodily injury.<br />
Slave Operator<br />
Master Operator<br />
Safety Edge<br />
Warning Sign<br />
Safety Edges<br />
Warning Sign<br />
Safety Edge<br />
Receiver<br />
RB709U<br />
(NOT INCLUDED)<br />
Operator<br />
Operator<br />
Operator<br />
Use Rigid Conduit<br />
for inbound AC.<br />
Safety Edge<br />
Photo Beams<br />
R4222<br />
(NOT INCLUDED)<br />
Dual <strong>Gate</strong> Interface<br />
Run Belden Wire® ONLY in its<br />
own conduit, 22 AWG ,<br />
1-pair shielded with GROUND.<br />
OPTIONAL<br />
Closed Position<br />
Positive Stop Plates<br />
Safety Edge<br />
OPTIONAL Closed Position<br />
Ground Stop Post and Plate<br />
Photo Beams<br />
R4222<br />
(NOT INCLUDED)<br />
Use PVC Conduit<br />
for Receiver<br />
Use Rigid Conduit<br />
for inbound AC.<br />
NOTE: A separate gate or entrance must be installed for pedestrian use. Not shown here.<br />
28