Service Manual
Service Manual
Service Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Distributor, general<br />
Cofiputelized ignition systems<br />
R*...q*5to'<br />
64<br />
M5<br />
Checking microswitch on 821 F-MPG 1981 and<br />
821 F-Cr '1982<br />
Connect a test lamp between battery (+) and terminal2<br />
(yellow wire) on microswitch.<br />
I amp snoulo be off when engrne is idl,ng. l' lamo is on,<br />
adjust microswitch as described below.<br />
Turn throttie pulley and check that lamp lights-<br />
Adjusting microswitch<br />
M6<br />
Pl6ce a 0.4 mmfeelergauge between adjustment screw<br />
Unscrew microswitch retaining screws and turn switch<br />
unlil lamp lights.<br />
Checking<br />
Place a 0,2 mm feelergauge between adjustnrent screw<br />
Lamp should light.<br />
Remove feeler qauge and insert a 0.4 mm feeler gauge.<br />
Lamp should be off.<br />
Checking microswitch on 821 F-LH 1982<br />
M7<br />
Disconnect connector from vacuum switch. Connecr a<br />
test lemp behveen batre-y ( ) a.ld orange wi'e o.<br />
Start engine.<br />
Test lamp should light with engine idling.<br />
Increase engine rpm and check that lighl goes oul.<br />
lf not, check hose to vacuum switch. lf intact, rep ace<br />
CI)<br />
o