VPN - Vanguard Networks

Vanguard VPN Tunneling
Configuration Examples
Introduction
Basic
Configuration
This section provides configuration samples for the Dynamic Tunnel Address
feature.
Note
In previous releases the proxy addresses were allowed to be blank but now the
proxy address parameters must be configured for dynamic tunnels since they are
used for tunnel identification purposes.
All the following configuration samples including this basic configuration sample
use the same configuration parameters for Encryption and IPSec as shown in
Figure 2-9, IPSec Configuration.
Configure Encryption Parameters
Enable Encryption: Enable
Configure IPSec Profile Table
Entry Number: 1
IPSec Profile Name: ipsec
Preshared Key Name: ipseckey
Configure ISAKMP Policy Table :
Entry Number: 1
Authentication Method: PRESHARED_KEY
Diffie-Hellman MODP Group: 1
Encryption Algorithm: DES_CBC
Pseudo Random Function: MD5
Configure IPSec Transform Set : Table
Entry Number: 1
AH Authentication Algorithm: MD5_HMAC
ESP Encryption Algorithm: DES_CBC
ESP Authentication Algorithm: NONE
Configure Preshared Key Table
Entry Number: 1
Preshared Key Name: ipseckey
Preshared Key Value: 123
Figure 2-9. Encryption and IPSec Configuration
Note
The examples show critical parameters only for Dynamic Tunnel Address
Operation. Use default values for IP related parameters not shown.
Tunneling 2-11
T0103-10, Revision L Release 7.3