Neptune TL - Appliance Blog
Neptune TL - Appliance Blog
Neptune TL - Appliance Blog
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Disassembly Procedures<br />
!<br />
WARNING<br />
7. Remove left and right Tumbler Bearings.<br />
8. Remove 4 Transmission mounting bolts.<br />
9. Lift Transmission Assembly from washer.<br />
10.Lock Spinner position with Short extension.<br />
11. Remove 6 Spinner mounting bolts.<br />
12.Lift Spinner From Washer.<br />
13.Remove Drain Pump Hose From Outer Tub.<br />
14.Unplug Motor Harness from Motor.<br />
15.Remove Motor Harness Strain Relief attached to<br />
Outer Tub.<br />
To avoid risk of electrical shock, personal injury or<br />
death; disconnect power to unit before servicing.<br />
18.Unhook Rear Struts From Outer Tub. Press the Rear<br />
Strut Rod near the connection point to the tub.<br />
19.Roll Outer Tub over pivoting on the Front Struts for<br />
support.<br />
Strain Relief And<br />
Screw<br />
20.Lift Outer Tub from washer and set on side or top.<br />
Drive Motor Removal<br />
1. Disconnect power supply to unit.<br />
2. Lift Top Cover.<br />
3. Remove Front Panel.<br />
4. Unplug Motor Harness from Motor.<br />
5. Loosen Drive Motor tension bolt.<br />
16.Unplug Heater Harness from Heater Assembly.<br />
Remove Heater Harness Strain Relief from Outer<br />
Tub (Heater Models Only).<br />
17.Unhook Tub Displacement Sensor and tuck out of<br />
way.<br />
Loosen Bolt<br />
46 16022808 Rev. 0 ©2003 Maytag <strong>Appliance</strong>s Company
Change language