MR-J2S-B Instruction Manual - Automation Systems and Controls

1. FUNCTIONS AND CONFIGURATION
(3) For MR-J2S-700B
Removal of the front cover
Reinstallation of the front cover
Front cover
hook
(2 places)
B)
A)
2)
1)
A)
2)
1)
Front cover socket
(2 places)
1) Push the removing knob A) or B), and put you
finger into the front hole of the front cover.
2) Pull the front cover toward you.
(4) For MR-J2S-11KB or more
Removal of the front cover
1) Insert the two front cover hooks at the bottom into the
sockets of the servo amplifier.
2) Press the front cover against the servo amplifier until the
removing knob clicks.
Mounting screws
(2 places)
Mounting screws (2 places)
1) Remove the front cover mounting screws (2 places)
and remove the front cover.
2) Remove the front cover mounting screws (2 places).
3) Remove the front cover by drawing it in the direction of arrow.
1 - 15