EverSmart Jazz Scanners - Kodak

98 Chapter 8 Maintenance
11. Open the top cover.
12. Screw in the four screws at the upper corners of the lamp assembly.
Switch ON the scanner, and verify that the new lamp illuminates
13.
after a few seconds.
8.1.2 Replacing the Reflective Lamps
The reflective lamps are located beneath the glass plate.
Light level is too low
The following message window is displayed on the screen.
To exit from the message window, perform one of the following:
Click Abort. The scanner application quits. Replace both lamps,
according to the procedure outlined below.
Ø
Ø
Click Ignore, and continue with the pre-scan/scan. Replace the
lamps when you have completed your work.