CRACKING RAY TUBES - Cracked Ray Tube

More documents

Recommendations

Info

***NOTE*** - This capacitor is polarized meaning that it has to be facing in the appropriate direction. Make sure you solder the NEGATIVE lead to the LOWER of the two squares. The negative side has the shorter lead and a vertical stripe along the side of the capacitor. 20
3. ADDING THE .1uF CAPACITORS (the two discs with “104” written on them) - These capacitors will be positioned between the upper and lower left most squares and the ground plate. Melt a blob of solder on these two squares and two blobs on the ground plate beside each. (Reference the pictures for exact positioning). - Re-heat the blobs and position the capacitors accordingly as in step 2. 21
Page 1 and 2: CRACKING RAY TUBES JAMES CONNOLLY K
Page 3: CONTENTS i. SYSTEM SCHEMATICS 6 ii.
Page 9 and 10: UNDERSTANDING A VGA CABLE A compute
Page 11 and 12: 1.2 SOLDERING THE GROUND PINS IN TH
Page 13 and 14: 1.4 SOLDERING THE R, G, AND B PINS
Page 15 and 16: 2.2 SOLDERING THE 1/4 INCH JACKS -C
Page 17 and 18: BUILDING A DIY VIDEO TRANSMITTER WH
Page 19: 2. ADDING THE 100uF CAPACITOR (the
Page 23 and 24: 5. ADDING THE COIL - Cut about 4”
Page 25 and 26: The variable capacitors soldered in
Page 27 and 28: - Solder each lead in place attachi
Page 29 and 30: 9. ADDING THE INPUT WIRES - Cut two
Page 31 and 32: 11. ADDING THE ANTENNA - Cut about
Page 33 and 34: BUILDING A DIY ELECTROMAGNET FOR TE
Page 35 and 36: 5. Hold the magnet wire taught to o
Page 37 and 38: 8. Repeat this process a few more t
Page 39 and 40: For more power, use more electricit
Page 41 and 42: HACKING A TELEVISION WITH A DIY ELE
Page 43 and 44: Now attach the other end of the cli
Page 45 and 46: 4. TESTING AND READJUSTING To test
Page 47 and 48: 5. FINISHING Once you have found th
Page 49 and 50: OPERATING Create the same setup as

CRACKING RAY TUBES - Cracked Ray Tube

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?