CRACKING RAY TUBES - Cracked Ray Tube

More documents

Recommendations

Info

10. ADDING THE BATTERY INPUT WIRES - Just like the last step, cut two shot pieces of wire and strip both ends. - Solder one of the wires to the ground plate (this will be the negative input from your 9volt battery). - Solder the other wire to the upper left square (this will be the positive input from your 9volt battery). 30
11. ADDING THE ANTENNA - Cut about 2 feet of wire and strip one end. - Solder the wire to the right most square of the triangle. 31
Page 1 and 2: CRACKING RAY TUBES JAMES CONNOLLY K
Page 3: CONTENTS i. SYSTEM SCHEMATICS 6 ii.
Page 9 and 10: UNDERSTANDING A VGA CABLE A compute
Page 11 and 12: 1.2 SOLDERING THE GROUND PINS IN TH
Page 13 and 14: 1.4 SOLDERING THE R, G, AND B PINS
Page 15 and 16: 2.2 SOLDERING THE 1/4 INCH JACKS -C
Page 17 and 18: BUILDING A DIY VIDEO TRANSMITTER WH
Page 19 and 20: 2. ADDING THE 100uF CAPACITOR (the
Page 21 and 22: 3. ADDING THE .1uF CAPACITORS (the
Page 23 and 24: 5. ADDING THE COIL - Cut about 4”
Page 25 and 26: The variable capacitors soldered in
Page 27 and 28: - Solder each lead in place attachi
Page 29: 9. ADDING THE INPUT WIRES - Cut two
Page 33 and 34: BUILDING A DIY ELECTROMAGNET FOR TE
Page 35 and 36: 5. Hold the magnet wire taught to o
Page 37 and 38: 8. Repeat this process a few more t
Page 39 and 40: For more power, use more electricit
Page 41 and 42: HACKING A TELEVISION WITH A DIY ELE
Page 43 and 44: Now attach the other end of the cli
Page 45 and 46: 4. TESTING AND READJUSTING To test
Page 47 and 48: 5. FINISHING Once you have found th
Page 49 and 50: OPERATING Create the same setup as

CRACKING RAY TUBES - Cracked Ray Tube

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?