CRACKING RAY TUBES - Cracked Ray Tube

More documents

Recommendations

Info

The finished magnet should look something like this. Make sure everything is secure with tape, but be sure to leave the top and bottom ends of the metal rod exposed. 10. To test out your magnet, first make sure you have sanded off the insulation on both sides of the wire. Use some clip leads or some wire to attach the + and – of a 9v battery to the two leads of magnet wire. It doesn’t matter which side goes to + or – at this point. (Changing that will switch the north and south polarity of the magnet). You should be able to pick up a few paper clips or bottle caps with just the 9v. 38
For more power, use more electricity. Try hooking it up to a DC power supply. The increase in available amps will increase the power of the magnet dramatically. But it will also increase the heat it generates. Sometimes it can be hot to the tough so be careful. Here are some examples: Holding a ½” drill bit at about 10V Holding a screwdriver at about 10V Holding its own weight against a metal plate at about 15V A lantern battery would also work much more efficiently than the 9v. If you’re comfortable you can also try a moderately powerful DC wall wart, but don’t play around with plugging stuff into the wall unless you are more experienced. Remember: Batteries can’t hurt you, but wall power can! 39
Page 1 and 2: CRACKING RAY TUBES JAMES CONNOLLY K
Page 3: CONTENTS i. SYSTEM SCHEMATICS 6 ii.
Page 9 and 10: UNDERSTANDING A VGA CABLE A compute
Page 11 and 12: 1.2 SOLDERING THE GROUND PINS IN TH
Page 13 and 14: 1.4 SOLDERING THE R, G, AND B PINS
Page 15 and 16: 2.2 SOLDERING THE 1/4 INCH JACKS -C
Page 17 and 18: BUILDING A DIY VIDEO TRANSMITTER WH
Page 19 and 20: 2. ADDING THE 100uF CAPACITOR (the
Page 21 and 22: 3. ADDING THE .1uF CAPACITORS (the
Page 23 and 24: 5. ADDING THE COIL - Cut about 4”
Page 25 and 26: The variable capacitors soldered in
Page 27 and 28: - Solder each lead in place attachi
Page 29 and 30: 9. ADDING THE INPUT WIRES - Cut two
Page 31 and 32: 11. ADDING THE ANTENNA - Cut about
Page 33 and 34: BUILDING A DIY ELECTROMAGNET FOR TE
Page 35 and 36: 5. Hold the magnet wire taught to o
Page 37: 8. Repeat this process a few more t
Page 41 and 42: HACKING A TELEVISION WITH A DIY ELE
Page 43 and 44: Now attach the other end of the cli
Page 45 and 46: 4. TESTING AND READJUSTING To test
Page 47 and 48: 5. FINISHING Once you have found th
Page 49 and 50: OPERATING Create the same setup as

CRACKING RAY TUBES - Cracked Ray Tube

Create successful ePaper yourself

Delete template?

Save as template?