Daelim Roadwin 125cc Owners Manual.pdf - Mojo

ENGINE OIL
Check the engine oil level each day before
riding the motorcycle.
The level must be maintained between the
upper and lower level marks on the oil
level gauge.
1. Start the engine and let it idle for a few
minutes.
2. Stop the engine and put the motorcycle
on its main stand on level ground.
3. After a few minutes, remove the oil
level gauge, wipe it clean, and reinsert
the gauge without screwing it in.
Remove the gauge. The oil level should
be between the upper and lower marks
on the oil level gauge.
4. If required, add the specified oil up to
the upper level mark.
Do not overfill.
5. Reinstall the oil level gauge.
Check for oil leaks.
UPPER
LEVEL
LOWER
LEVEL
CAUTION
●Running the engine with insufficient
oil pressure may cause serious engine
damage.
OILLEVELGAUGE
LIGHTS AND WINKER
Start the engine and make sure the lights
turn on. Also check to see if the lights are
damaged or if there is dirt on them.
Turn the main switch to ON.
While separately operating the front and
rear brakes, check to see if the brake light
turns on. Also check to see if there is any
damage to the lens or if there is dirt on the
brake light.
Turn the main switch to ON.
Check to see if all the winker in the front
and rear of the vehicle (including left and
right sides) are flashing properly. At the
same time, check to make sure that the
automatic sound signal of the winker is
working. Check also to see if any of the
lens are damaged or dirty.
25