Daelim Roadwin 125cc Owners Manual.pdf - Mojo
Daelim Roadwin 125cc Owners Manual.pdf - Mojo
Daelim Roadwin 125cc Owners Manual.pdf - Mojo
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
BRAKE PAD WEAR<br />
INSTALLATION NOTES:<br />
●To install the rear wheel, reverse the<br />
removal procedure.<br />
●Tighten the axle nut to the specified<br />
torque.<br />
REAR AXLE NUT TORQUE : 6.0~8.0kgf.m<br />
●Adjust the drive chain. (page 39)<br />
Brake pad wear depends upon the severity<br />
of usage, the type of riding, and road<br />
conditions. (Generally, the pads will wear<br />
faster on wet and dirty roads.)<br />
Inspect the pads at each regular<br />
maintenance interval. (page 33)<br />
<br />
CAUTION<br />
●When installing the wheel, carefully<br />
fit the left brake disk between the<br />
brake pads to avoid damaging the<br />
pads.<br />
[FRONT/REAR BRAKE]<br />
●Check the cutout in each pad.<br />
●If either pad is worn to the cutout,<br />
replace both pads as a set.<br />
●See your authorized <strong>Daelim</strong> dealer for<br />
this service.<br />
<br />
CUTOUTS<br />
●After installing the wheel, apply the<br />
brake several times and then check if<br />
the wheel rotates freely. Recheck the<br />
wheel if the brake drags or if the wheel<br />
does not rotate freely.<br />
WARNING<br />
●If torque wrench was not used for<br />
installation, see you authorized dealer<br />
as soon as possible to verify proper<br />
assembly. Improper assembly may lead<br />
to loss of braking capacity.<br />
CUTOUTS<br />
43