caledonian telephone cable

More documents

Recommendations

Info

ADDISON MICA/LSZH Insulated & LSZH Sheathed Fire Resistant Cables to DIN VDE 0815 JE-H(St)H…Bd FE180 E90 JE-H(St)H…Bd FE180 E90 BMK APPLICATION The cables are similar in design and application to CW 1600, but with fire barrier tape. They are used for the internal wiring of building when the circuit integrity during fire is paramount. The cable is intended to take the place of LSZH sheathed cables and will withstand similar environments with a similar working life. The cables are intended for use in fire fighting plants with mica tapes, with and without aluminium foil and LSZH outer sheath. STANDARDS • EN 50200:2000-02 • EN 50266 • EN 50267 • EN 50268 • BS 6387 • IEC 60331 CONSTRUCTION • Conductors: Solid annealed bare or tinned copper sized 0.8mm as per class 1 of VDE 0295/IEC 60228. • Fire Barrier: Mica tape. • Insulation: LSZH compound HI1 as per VDE 0207-23. • Twisted Pairs: Insulated conductors are twisted into pairs with varying lay length to minimize crosstalk. • Cabling Element: Twisted Pairs. • Core Assembly: The twisted pairs are stranded to the core in layers. • Core Wrapping: One or more non hygroscopic polyester tapes are helically or longitudinally laid with an overlap prior to sheathing. • Screen: A laminated Aluminium/Polyester tape in contact with solid copper 0.6mm or 0.8mm drain wire. • Inner bedding (for armoured cables): PE or LSZH compound HM2 as per VDE 0207-24 • Armour (for armoured cables): Either corrugated steel tape armour or galvanized steel wire is applied over an inner polyethylene sheath. For steel tape armour, the 0.15mm thick steel tape is coated with a copolymer and applied with an overlap. For steel wire armour, single layer of galvanized steel wire armour is applied. • Sheath: LSZH compound HM2 as per VDE 0207-24. • Ripcord: Nylon ripcord may be placed parallel to the cores to facilitate sheath removal. • Drain Wire: A solid tinned earth/continuity wire shall be laid longitudinally for screened cables. TYPE CODES JE- H Fire Alarm Cable Halogen Free & Zero Halogen 122 Caledonian Telephone Cables www.addison-cables.com www.caledonian-cables.co.uk
Caledonian INDOOR TELEPHONE CABLES www.caledonian-cables.co.uk www.addison-cables.com Bd (St) FE180 E90 Unit stranding. Static Shield of aluminium tape Insulation Integrity (950°C 180 minutes) 90 minutes Circuit Integrity. ELECTRICAL PROPERTIES Nominal Conductor Diameter mm 0.8 Conductor Size mm 2 0.5 Maximum Conductor Resistance @20°C Ω/km 34.6 Maximum Loop Resistance @20°C Ω/km 73.2 Minimum Insulation Resistance @500V DC @20°C MΩ . km 100 Maximum Average Attenuation @0.8KHz dB/km 1.1 Average Mutual Capacitance nF/km 120 Capacitance Unbalance K1 @0.8KHz pair-to-pair pF/100m 200 Working Voltage V 300 Nominal Insulation Thickness mm 0.4 Nominal Insulated Conductor Diameter mm 1.6 MECHANICAL AND THERMAL PROPERTIES Temperature range during operation (fixed state): -30°C – +70°C Temperature range during installation (mobile state): -20°C – +50°C Minimum bending radius: 10 x Overall Diameter (unarmoured cables);15 x Overall Diameter (armoured cables) FIRE HAZARD PERFORMANCE 1) Minimum Smoke Emission IEC 61034, EN 50268 (New: EN 61034), VDE 0482-268 (New: VDE 0482-1034) These standards specify a method to measure the generation of smoke from cables during fire. The result is expressed as percentage of light transmitted. Usually, the smoke density shall not be less than 60%. 2) Halogen Free IEC 60754-1, EN 50267-2-1 These standards specify a method for determination of the amount of halogen acid gas, evolved during combustion of compound. The hydrochloric acid yield should be less than 0.5%. 3) Non corrosive gases IEC 60754-2, EN 50267-2-2, VDE 0482-267 These standards specify a method for determination of acidity of gas evolved during combustion of cables by measuring PH and conductivity. The specimen is deemed to pass this test if the pH value is less than 4.3 when related to 1 litre of water and conductivity is less than 10 μs/min. 4) Reduced Fire Propagation IEC 60332-3C, EN 50266-2-4, VDE 0482-266-2-4 These standards specify a method for flame propagation test for bunched cables. 5) Flame Retardancy IEC 60332-1, VDE 0482-265-2-1 These standards specify a method for flame propagation test for single core cables. 6) Insulation Integrity FE 180 DIN VDE 0472-814, IEC 60331, EN 50200, VDE 0482-1 ADDISON 123
Page 2 and 3:
Caledonian TELEPHONE CABLES
Page 4 and 5:
ADDISON PVC Insulated Jumper Wires
Page 6 and 7:
ADDISON Solid PE Insulated & PE She
Page 8 and 9:
ADDISON (Continued from previous pa
Page 10 and 11:
ADDISON ELECTRICAL PROPERTIES Nomin
Page 12 and 13:
ADDISON Solid PE Insulated & LAP Sh
Page 14 and 15:
ADDISON COLOUR CODE Standard colour
Page 16 and 17:
Page 18 and 19:
ADDISON shield and sheath within th
Page 20 and 21:
Page 22 and 23:
ADDISON Solid PE Insulated & AP She
Page 24 and 25:
Page 26 and 27:
ADDISON Fig 8 Solid PE Insulated &
Page 28 and 29:
ADDISON Solid PE Insulated & AP She
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
ADDISON ELECTRICAL PROPERTIES Nomin
Page 40 and 41:
Page 42 and 43:
ADDISON Solid PE Insulated & LAP Sh
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
ADDISON Cellular PE Insulated & PE
Page 50 and 51:
Page 52 and 53:
ADDISON Cellular PE Insulated & PE
Page 54 and 55:
ADDISON Cabling Element No. a-wire
Page 56 and 57:
Page 58 and 59:
ADDISON shield and sheath within th
Page 60 and 61:
Page 62 and 63:
ADDISON Foam Skin Insulated & LAP S
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
ADDISON Fig 8 Foam Skin Insulated a
Page 70 and 71:
Page 72 and 73:
ADDISON the cable. The water resist
Page 74 and 75:
ADDISON Foam Skin Insulated & LAP S
Page 76 and 77: ADDISON OPTIONAL CONSTRUCTION • A
Page 78 and 79: ADDISON (Continued from previous pa
Page 80 and 81: ADDISON OPTIONAL CONSTRUCTION • A
Page 82 and 83: ADDISON Cable Code Number of Pairs
Page 84 and 85: ADDISON Foam Skin Insulated & LAP S
Page 90 and 91: ADDISON PVC Insulated Self Supporti
Page 94 and 95: ADDISON Drop Wires No. 1, 2, 6 & 8
Page 96 and 97: ADDISON Drop Wires No. 12, 10B, CAD
Page 98 and 99: ADDISON PVC Insulated Jumper Wires
Page 100 and 101: ADDISON PVC Insulated Jumper Wires
Page 104 and 105: ADDISON MECHANICAL AND THERMAL PROP
Page 108 and 109: ADDISON Indoor Central Office Cable
Page 110 and 111: ADDISON ** At the manufacturer’s
Page 112 and 113: ADDISON PE Insulated & LSZH Sheathe
Page 116 and 117: ADDISON ELECTRICAL PROPERTIES Nomin
Page 118 and 119: ADDISON PE Insulated & PVC/LSZH She
Page 120 and 121: ADDISON Quad 5 White The tracer uni
Page 124 and 125: ADDISON ELECTRICAL PROPERTIES Condu
Page 128 and 129: ADDISON These standards specify the
Page 130 and 131: ADDISON PE Insulated Category 3 UTP
Page 134 and 135: ADDISON ADSL Connecting Cables APPL
Page 136 and 137: ADDISON XDSL Connecting Cables APPL
Page 138 and 139: ADDISON PE Insulated ISDN Primary A
Page 140 and 141: ADDISON PE Insulated ISDN Basic Acc
Page 142 and 143: ADDISON PE Insulated Air Core/Jelly
Page 150 and 151: ADDISON DIMENSIONS AND WEIGHT VDE C
Page 152 and 153: ADDISON VDE Order Code A-BCDEFG HxI
Page 154 and 155: ADDISON Caledonian Order Code TPA-B
Page 156 and 157: ADDISON C) Colour Code According to
Page 158 and 159: ADDISON E) Colour Code & Cable Make
Page 160 and 161: ADDISON The insulating cores of fiv
Page 162 and 163: ADDISON G) Colour Code & Cable Make
Page 164 and 165: ADDISON 160 Caledonian Telephone Ca
Page 166 and 167: ADDISON H) Colour Code According to
show all

caledonian telephone cable

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?