Install Instructions - Williams Sound

RECEIVER FREQUENCY CHANGE INSTRUCTIONSFIGURE 10: R7 RECEIVER TUNINGTuning CoilThis is a small, square, bright metal can with ascrewdriver slot in the top center. Using a plastictuning tool (PLT 005), rotate the Tuning Coilslowly and gently. Do not press down on theadjustment. When you find the signal transmittedby your system, adjust for the loudest and clearestsound possible.Tuning for the R7 and R-16 Receivers is determined by a single tuning coil. (See Figure 10.)A plastic tuning wrench (PLT 005) is needed to adjust the receiver tuning coil.Most Williams Sound receivers, including R7’s, are set at the factory to 72.9 MHz. (Yoursmay have been set to another channel when they were ordered.) To change the frequency ofR7 receivers:Step 1:Step 2:Step 3:Step 4:Step 5:Step 6:The receiver must be tuned under moderate or weak signal conditions. Set the T4Transmitter’s RF Output Power to QUARTER. (See Figure 9.) Play a CD orcassette through the sound system, or have someone speak into a microphone.Make sure the transmitter is set for the channel to which you want to tune thereceiver, then move 50-75 feet away from the transmitting antenna.Open the battery compartment, then lift up on the battery flap to open the back ofthe receiver. This will expose the circuit board.Locate the tuning coil. (See Figure 10.) The only adjustable item in the unit, thetuning coil is a small, square, bright metal can with a screwdriver slot in the topcenter.Use the earphone supplied with the receiver to listen for the transmitted signal.Slowly and gently rotate the tuning coil with a plastic tuning tool(PLT 005), Do not press down on the coil. When you find the signal transmitted byyour system, adjust for the loudest and clearest sound possible.Re-tune all the receivers, marking the new frequency inside each’s case for futurereference.22Williams Sound ®Helping People Hear