Indoor unit

VE Chassis5. Wiring DiagramsCeiling & Floor/Ceiling SuspendedCONNECTORNUMBERSPEC.DESCRIPTIONCN-POWER AC power supply AC power line input for indoor controllerCN-MOTOR1 Fan motor output Motor output of BLDCCN-MOTOR2 Fan motor output Motor output of BLDCCN-PIPE/OUT Discharge pipe thermistor Pipe out thermistorCN-PIPE/IN Suction pipe sensor Pipe in thermistorCN-ROOM Room sensor Room thermistorCN-REMO Remote controller Remote control lineCN-FLOAT Float switch input Float switch sensingCN-EEV EEV output EEV Control outputCN-OPTION Option pwb. Communication between main and optionCN-COM Communication Communication between indoor and outdoorCN-D/PUMP Drain pump output AC Output for drain pumpCN-POWER AC power supply AC Power line input for indoor controllerCN-DISPLAY Display wire Display wire lineCN-DOOR Door lock switch Door lock switch lineCN-CC Dry contact Dry contact lineDip Switch Setting ON OFF RemarksSW3 GROUP Master Slave Group Control setting using Wired Remote ControllerOld Dry Contact Mode Setting1. Variable : Auto/Manual Mode can be chosen by Wide wiredSW4 DRY CONTACT Variable Auto remote controller or Wireless remote controller(When shipped from Factory → Manual Mode)2. Auto : For Dry Contact, it is always Auto mode.1. Duct model-. OFF : Default(not operate continuosly )-. ON : Fan operate continuoslySW5 EXTRA 1 ON OFF 2. Cassette Model : No Function3. Ceiling Suspended Model-. OFF : Ceiling(default)-. ON : FloorCAUTIONFor Multi V Model, Dip Switch 1,2,6,7,8 must be set OFFThat dip switch is used for the other model.Ceiling & FloorCeiling SuspendedIndoor unit10-7