15C 20C MFS - Tohatsu

More documents

Recommendations

Info

54 INSPECTION AND MAINTENANCEReplacing the anodeThe anode protects the outboardmotor from galvanic corrosion(metal corrosion caused by feebleelectoricity).Anodes are installed under the untiventilationof the gear case, the leftcramp bracket (port side) and the leftmount bracket (port side).When an anode is worn down under2/3 of its original size (of new port),replace it.Notes● Never grease or paint the anode.● At each inspection re-tighten theanode attaching bolt. As it is likelyto be subjected to electrolyticcorrosion.Checking and Refilling Oil in thePower Trim & Tilt.1 Check the oil level of the reservoirtank as shown on the right whilethe tank is kept in a verticalposition. Tilt the outboard motor upto check the oil level in the tank.Remove the oil cap by turningcounter-clockwise, then check ifthe oil level reaches the bottomline of the plug hole.Oil capOil level10AnodeAnode(Trim tab)! WARNING● Be sure that outboard motor issecured to transom or servicestand, or accidental drop or fall ofoutboard motor could lead to severepersonal injury.● Be sure to lock outboard motor ifit is tilted up, or accidental fall ofoutboard motor could lead to severepersonal injury.● Do not go under outboard motortilted up and locked, or accidentalfall of outboard motor could lead tosevere personal injury.AnodeAnode
INSPECTION AND MAINTENANCE 55! CAUTIONDo not unscrew the oil plug with theoutboard motor tilted down. Pressurizedoil in the oil tank may spurt out.Recommended oilUse an automatic transmissionfluid or equivalent.Recommended oils are as shownbelow.ATF Dexron IIIAir purging from the Power Trim andTilt unit.Entrapped air in the Power Trim& Tilt unit will cause poor tiltingmovement and increased noise.With the outboard motor mountedon the boat, set the manual releasevalve to the Manual side, andtilt the outboard motor manuallyup/down 5-6 times while checkingthe oil level. When done, closethe valve by turning it clockwisetowards the Power side.10POWERMANUAL
Page 1 and 2:
OWNER’SMANUALMFS15C20COB No.003-1
Page 6 and 7: 1011121314INSPECTION AND MAINTENANC
Page 9 and 10: GENERAL SAFETY INFORMATION 9SAFE OP
Page 11 and 12: SPECIFICATIONS 11EP , EPT1ItemMODEL
Page 13 and 14: NAMES OF PARTS 132Power Tilt TypeEP
Page 15 and 16: INSTALLATION1. Mounting the outboar
Page 17 and 18: INSTALLATION 172. Installing the re
Page 19 and 20: INSTALLATION 19NoteMinimum recommen
Page 21 and 22: PRE-OPERATING PREPARATIONS 21becaus
Page 23 and 24: PRE-OPERATING PREPARATIONS 23! CAUT
Page 25 and 26: PRE-OPERATING PREPARATIONS 257. Eng
Page 27 and 28: ENGINE OPERATION 27! WARNINGWhen op
Page 29 and 30: ENGINE OPERATION 29! CAUTIONWhen us
Page 31 and 32: ENGINE OPERATION 31SlowlyQuicklyNot
Page 33 and 34: ENGINE OPERATION 336
Page 35 and 36: ENGINE OPERATION 355. Forward and r
Page 37 and 38: ENGINE OPERATION 376. StoppingEP, E
Page 39 and 40: ENGINE OPERATION 39EFT, EPT type■
Page 41 and 42: ENGINE OPERATION 41■ Shallow wate
Page 43 and 44: ENGINE OPERATION 43EFT, EPT typeThe
Page 45 and 46: TRAILERING! WARNINGDo not go under
Page 47 and 48: ADJUSTMENT 474. Trim Tab Adjustment
Page 49 and 50: INSPECTION AND MAINTENANCE 491. Dai
Page 51 and 52: INSPECTION AND MAINTENANCE 51Washin
Page 53: INSPECTION AND MAINTENANCE 53Replac
Page 57 and 58: INSPECTION AND MAINTENANCE 57NotesD
Page 59 and 60: INSPECTION AND MAINTENANCE 59Cleani
Page 61 and 62: INSPECTION AND MAINTENANCE 613. Off
Page 63 and 64: INSPECTION AND MAINTENANCE 636. Col
Page 65 and 66: TROUBLESHOOTING 65Engine falling to
Page 67 and 68: TOOL KIT AND SPARE PARTSTOOL KIT AN
Page 69 and 70: PROPELLER TABLEPROPELLER TABLE 69Us
Page 72: OWNER’S MANUALMFS15C20CTOHATSU CO
show all

15C 20C MFS - Tohatsu

Create successful ePaper yourself

Delete template?

Save as template?