Scantronic 9800+ User Guide - RSJ Security Systems Ltd.

4. Special FunctionsTable 1 (Cont'd) . Log Event CodesCode MeaningLt Control unit lid tampero1 to o16 † Zone omittedP1 to P4 Remote keypad dual key PA alarmPF Mains power failurePL Print log.r1 to r4 Remote keypad enclosure tamperrP Remote keypad missingrrInstaller resetrt Remote keypad excess key presses tamperS1 to S16 † Zone soak TestSr System resetSt Set timet1 to t16 † Zone tamper violationtrTamper return faultu1 to u8 Access user (u9 = Duress, u0 = keys witch)†When showing zones 10 to 16 the display alternates between the letter 'c'and the number of the zone.Turning the Chime On/OffYour system may be programmed so that a chime tone sounds whenevercertain doors are opened while the system is unset. If your system has anExit Terminate button, then it will act as a door bell while Chime is on. To turnChime on or off:1. Key in your access code.The display shows "_ _ "2. Press 7 followed by y (Clear).Testing the SystemBell TestYou can test that the internal and external sounders, and the strobe, are allworking as follows:1. Key in your access code.The display shows "_ _ "2. Press 8.The system turns the external sounder, strobe, internal sounder(s) andkeypad sounders on for three seconds each, one after the other.3. Press y (Clear) to finish the test.16 496247 Issue 4