Mounting instruction for conversion kit Monster mod

Position 30Parts are inbag H1. Cover the outlet port of the enginewith an adhesive tape.2. Saw off the housing partwith an metal hand saw, seealso illustration in position 31.Position 31aParts are inbag HDriving directionClutch springClutch blocksPosition 30bParts are inbag H1. Disassemble the complete engine from your existing 2WD model.Remove muffler, airfilter, gearplate and clutch. Make sure no dirt gets in the outlet port of the engine.2. Dismount the clutch spring by twisting the clutch blocks.3. Mount new clutch spring as described in position 30a-30c.4. Now disperse the clutch blocks slightly until the clutch blocks lay straight parallel again, position30b.5. Push the clutch blocks on top of each other by using tongs or a vice, until they lock. Position30c.6. Push the shaft washers on the dowel screws for the clutch blocks and press them into theclutch blocks from the side with the arrows (engine running direction). Fix them on the clutchblock carrier using 6x15x1 disks. Position 30d and 31.7. Disassemble steel fixing plates and ball bearing 10x19x7 from the existing 2WD parts andmount them to the large plastic mount 4WD.8. Now mount the large plastic engine mount 4WD with the long and short steel fixing plates onthe engine using 4,2x13 pan-head screws as described in position 31.Hint: If you use the FG piston punching pin Item N°. 08542 the mounting of the clutch will be considerablysimplified.All metric screws need to be securedwith thread lock fluid.Position30cParts are inbag HPosition 31Parts are inbag HPosition 30dParts are inbag HPlastic enginemount large4WDBall bearing10x19x7Disk6x15x1Steel fixing plate longSteel fixing plate shortScrew4,2x13Screw4,2x13Shaft washerDowel screw forclutch blocks