Mounting instruction for conversion kit Monster mod

Position 3Parts are inbag CFront differentialmounted2. Mount front differential gear, deflection roller16mm, toothed belt wheel 12 teeth in the leftfront axle housing as described in position 3.Front axlehousing left3. Now put the toothed belt on the front differentialgear, also deflection roller 16mm,toothed belt wheel with 12 teeth as describedin position 3.Toothed beltDeflection roller16mmToothed belt wheel12 teethFront axlehousing right4. Press the right front axle housing on the front differentialgear, also deflection roller 16mm and the toothedbelt wheel with 12 teeth (position 4).Position 4Parts are inbag C1. Impress ball bearings 6x16x6 in both frontaxle housings left and right.Front axlehousing left5. Put the complete front axle housing onthe alloy chassis and fasten it using the4,2x16 countersunk screws.Front differentialgearAlloy chassisPosition 5Parts are inbag B+CFront axlehousing right1. Put the toothed belt around the rear differential gearas described in position 5.2. Press the left and right rear axle mounts on the ballbearings of the rear differential gear as pictured.3. Put the left and right rear axle mounts on the alloychassis and fix them with the 4,2x16 countersunkscrews on the chassis.Countersunkscrew M4,2x16Rear axle mountleftToothed beltUpper part beltchannelLower part beltchannelWhen mounting pay attention that the closedside of the lower belt channel facesupwards. The teeth of the toothed belt arenot allowed to touch each other.Rear axle mountright1. Place the lower part of the belt channel (with the closed side facingupwards) on the bottom part of the toothed belt. Then push the top partof the belt channel in the bottom part. Now insert the complete beltchannel in the opening of the front axle housing (see position 5a). Makesure that the toothed belt is running smoothly.2. Fix the belt channel from underneath to the alloy chassis using the4,2x16 countersunk screws.Countersunkscrew M4,2x16