Mounting instruction for conversion kit Monster mod

Position 41Parts are inbag JFront axlestiffeningScrewM5x16DiskØ5,3Steering servoServosaverPlastic rc-plate 4WDServo rodsTrack rodFront uprightleftStop nutM4DiskØ4,3Screw4,2x16ScrewM4x20Screw2,9x16Alloy chassisScrew4,2x161. Mount the plastic rc-plate 4WD underneath the front axle stiffeningto the alloy chassis using 4,2x16 countersunk screws.2. Now mount the servo saver underneath the plastic rc-plate4WD by using M5x16 pan-head screw and Ø5,3 disk as pictured.Use screw retention lacquer.Dirt, but also longer downtimes canaffect the function and free movementof the servo saver. Therefore werecommend to spray some penetratingoil between tension sleeve andservo saver part A+B. Then press servosaver part A downwards againstthe spring and check the function. If itdoes not function smoothly you haveto dismount and clean the part.A stiff servo saver can cause a servodamage.Position 42Parts are inbag JFront axlestiffeningScrewM5x16DiskØ5,3ServosaverPlastic rcplate4WDPosition 43Parts are inbag JTrack rodFront uprightleftStop nutM4DiskØ4,3ScrewM4x203. Switch on the remote control system, set the trimming ofthe steering to central position. Adjust the servo saver incentre to the chassis. First mount one servo rod to theservo arm of the steering servo using a 2,9x16 pan-headscrew, then mount the second servo rod. Both servo rodsshould be adjusted in the same length. You should be ableto mount both servo rods easily and without any resistanceto the servo arm of the steering servo using 2,9x16 panheadscrews, position 41-43.4. Mount the track rods to the front uprights by using M4x20cylinder screws, Ø4,3 disks and M4 stop nuts as describedin position 43.All metric screws need to be secured with thread lock fluid.