Mounting instruction for conversion kit Monster mod

Position 5aParts are inbag B+CAlloy chassisFix the belt channel from underneath to the alloychassis with the 4,2x16 countersunk screws.Front axle housingleftUpper partbelt channelFront axlehousingrightToothed beltLower part beltchannelPosition 6Parts are inbag BCountersunkscrew M4,2x16Screw4,2x16Fitting position fortoothed belt wheel40 teethScrewM4x14Disk Ø4,31. Impress the plastic bearing seatwith inbound collar (pay attention tofitting position) in the left and rightstretching pulley housing as describedin position 6.Tipp: The position of the front bearing seat is made forthe front plastic toothed belt wheel with 42 teeth. Theposition of the rear bearing seat is made for the frontplastic toothed belt wheel with 40 teeth.2. Push the bearing shaft for the stretching pulleyhousing centrically in the 3 ball bearings 10x19x7.3. Impress the bearing shaft which is equipped withball bearings in the bearing seat of the left andright stretching pulley housing and fix it withM4x14 pan-head screws and Ø4,3 disks.Stretching pulleyhousing leftFitting position fortoothed beltwheel 42 teethBall bearing10x19x7Bearing shaftfor stretchingpulley housingCollarAll metric screws need to be secured with thread lock fluid.Plasticbearing seatPosition 7Parts are in bag BStretching pulleyhousingright1. Place the mounted stretching pulley housing ob toothedbelt and belt channel as described in position 7and fix it on the alloy chassis using the 4,2x16 countersunkscrews. For this purpose, slightly move the belt.2. When the assembly is performed, turn the belt in runningdirection. Make sure the belt is easily rotatable.Stretching pulleyhousing mountedBelt channel mountedCountersunkscrew 4,2x16Alloy chassis