PicC 9.50 dsPIC Manual.pdf

Error and Warning Messages(802) invalid address after "end" directive (Assembler)The start address of the program which is specified after the assembler END directive must be a labelin the current file.(803) undefined temporary label (Assembler)A temporary label has been referenced that is not defined. Note that a temporary label must have anumber >= 0.(808) add_reloc - bad size (Assembler)This is an internal compiler error. Contact HI-TECH Software technical support with details.(809) unknown addressing mode * (Assembler, Optimiser)An unknown addressing mode was used in the assembly file.(815) syntax error in chipinfo file at line * (Assembler)The chipinfo file contains non-standard syntax at the specified line.(817) unknown architecture in chipinfo file at line * (Assembler, Driver)An chip architecture (family) that is unknown was encountered when reading the chip INI file.(829) unrecognized line in chipinfo file at line * (Assembler)The chipinfo file contains a processor section with an unrecognised line. Contact HI-TECH Supportif the INI has not been edited.(832) empty chip info file * (Assembler)The chipinfo file contains no data. If you have not manually edited the chip info file, contact HI-TECH Support with details.(834) page width must be >= 60 (Assembler)The listing page width must be at least 60 characters. Any less will not allow a properly formattedlisting to be produced, e.g.:LIST C=10; the page width will need to be wider than this313