E-3 Manual - MGL Avionics

More documents

Recommendations

Info

Infinity E-3 Operating <strong>Manual</strong> Page 1210,20,30,40,50,60,70,80,90,100 – The filter factor can be set to any of these values independent of your scale selection.Choose a filter setting that results in a smooth, high resolution RPM display. A filter setting too low for your setup willresult in a “jumpy” display. RPM display will change at your base resolution and no smoothing will happen. Choose thelowest setting that will result in a smooth display for greatest sensitivity of the reading.4.8 Pressure SetupThe pressure setup menu item allows the user to adjust the pressure sender properties.Move the highlight over this menu item and press the rotary button to return to the main menu.Select whether to use the pressure sender or not.Select if you are using a resistive or a linear voltage output pressure sender.Select what type of pressure sender you are using. Select “VDO” for VDO/Resistive pressuresenders or “USER” for a custom sender. This menu item is fixed on “USER” if the linear pressuretype is selected.If the “Resistive” pressure sender is selectedEnter the maximum resistance of your pressure sender. Common VDO pressure senders aretypically 180 Ohms.Enter the maximum pressure for your pressure sender. If you are using a VDO 10 bar pressuresender then enter in 10.0, if you are using a VDO 5 bar, then enter in 5.0, if you are using a VDO 2bar then enter in 2.0. Enter the maximum pressure in the selected unit VDO 10BAR = 145PSI.Select whether your pressure sender increases resistance with pressure or decreases resistancewith pressure. VDO senders normally increase resistance with pressure.If the “User” pressure sender is selectedIf the sender type is set to “USER”, then use this menu option to calibrate yourtemperature sender. See section 4.9.1 for more information.
Infinity E-3 Operating <strong>Manual</strong> Page 13Menu options for all sender typesChoose one of a selection of labels to suit your pressure input so you can identify it easily.Select whether you want to display the pressure in Bar, PSI or PSI(0.1). The PSI(0.1) is for lowrange pressure senders e.g. 7PSI.Set the range of the pressure sender. This is the maximum that the bargraph display will go to.This allows the user to zoom into the top half of the bar graph resulting in a higher display resolution.This option set to “ON” is recommended.Select whether to use the low pressure alarm.Use this to set the low pressure alarm set-point.Select whether to use the high pressure alarm.Use this to set the high pressure alarm set-point.4.9 Temperature SetupThe temperature setup menu item allows the user to adjust the temperature sender properties.Move the highlight over this menu item and press the rotary button to return to the main menu.Select whether to use the temperature sender or not.
Page 1: Infinity E-3Universal Engine Monito
Page 5 and 6: Infinity E-3 Operating Manual Page
Page 11: Infinity E-3 Operating Manual Page
Page 25: Infinity E-3 Operating Manual Page

E-3 Manual - MGL Avionics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?