E-3 Manual - MGL Avionics

Infinity E-3 Operating Manual Page 43.2 Special Rotax 912/914 display modeIn this mode the temperature and pressure NTC inputs becomes CHT channel one and CHT channel 2 respectively. AllCHT setups must still be done under the “CHT SETUP” menu. The sender for the temperature and pressure setup mustbe set for “OFF”. A probe setting “NTC” must be selected for the probe setting in the “CHT SETUP” menu. The number ofEGT probes can be selected from 0 to 4.The reason for using the NTC inputs is that the sensors Rotax use are standard NTC temperature probes and not of athermocouple type.Maximum RPMreached markerAnalog RPM displayRPM AlarmDigital RPM readoutEGT ValueEGT alarmlimitCHT ValueMaximum valuereached indicatorMaximum valuereached indicatorCHT alarmlimitEGT groupindicatorTemperaturedisplay unitCHT groupindicator3.3 Start/Stop Flight DisplayPress the F1 key during the normal display mode to manually start/stop a flight. This key is only active if the E-3 is setupto select the manual flight option under the “FLIGHT LOG” setup menu.