ANAMORPHIC LENS ATTACHMENT PLATE - Planar

More documents

Recommendations

Info

If the lens must be removed for any length of time it is recommended that a similar weight be suspended from the front of the attachment kit to balance the weight of the projector. This will minimize unusual stresses on the ceiling mount system. Proceed to “Final Adjustments” later on in this manual. Planar A480-PL User Manual and Installation Guide, Version 2.3, copyright 2009, all rights reserved, Planar Inc. Page 10
Viper (PD7170) installation instructions CONNECTING THE AKPro ATTACHMENT PLATE AND CEILING MOUNT (Planar/Premier PDS mount P/N 997-5351-00 and Phillips screwdrivers required) 1. Position the projector bottom-up on a soft surface. Consult the Attachment Plate Diagram for plate orientation, mounting hole locations and required screws and spacers for the Viper. Align the bottom part of the Planar/Premier PDS mount with the attachment plate holes and insert and tighten each M4x30 screw through an appropriate silver washer and lock washer, the designated holes in the Attachment Plate, then through the 5/8” nylon spacers and finally into the projector ceiling mount holes. Planar A480-PL User Manual and Installation Guide, Version 2.3, copyright 2009, all rights reserved, Planar Inc. Page 11
Page 1 and 2: AKPro system with ATH1 transport sh
Page 3 and 4: USING the AKPro ATTACHMENT KIT The
Page 5 and 6: Panamorph lens and mounting bracket
Page 7 and 8: PD8130/PD8150 installation instruct
Page 9: Planar A480-PL User Manual and Inst
Page 13 and 14: MOUNTING THE ATH1 TRANSPORT 1. DO N
Page 15 and 16: Planar A480-PL User Manual and Inst
Page 17 and 18: Programming Connect the included po
Page 19: Aspect Ratio Matrix Native Source A

ANAMORPHIC LENS ATTACHMENT PLATE - Planar

Create successful ePaper yourself

Delete template?

Save as template?