bremer VIVA

11.3 Connecting the water supplyObserve the national guidelines for the water connection.For a water hardness of over 5° dkH (carbonate hardness), we recommend thatyou have to install a water softener in the water inlet line. Observe theinstructions on installing and using the water softener. We recommend to install an electronic water monitor to guard against waterdamage. A water tap and water filter must be installed in an easily accessible positionupstream of the water inlet hose. Use a fabric pressure hose which does not corrupt taste to extend the supplyhose. The diameter must not be smaller than the supply hose fitted at thefactory. Before connecting, rinse through the water line and the fabric pressure hose sothat no dirt particles enter the coffeemachine. Check all connections for leaks. Maximum water line pressure: 1.0 MPa (10 bar). Minimum flow pressure: 0.3 MPa (3 bar). Water temperature: up to approx. 40° C.11.4 Connecting the water outletInstall a stench trap on the drainage hose (siphon).Lay the hose with a gradient to the drain.Seal and secure the hose at the drainage pipe.The inlet and drainage hoses must not be bent or squashed.47