573-093-00 : Seiko-Epson NS5000-6000 Handler I-F ... - Zzybot.net

NS5000/6000 Handler Interface Manual for the Catalyst Test System3) Position the interface assembly plate under the handler.The keyholes in the plate must go over the screws installed in step 1 (see Figure 10).4) Secure the interface assembly plate in place then loosen each fastener 1 1/2 to 2 turnsso that the assembly can be repositioned.5) Fasten (torque: 24 inch-lbs) two guide pins (pn 480-018-02) to the interface assemblyplate (see Figure 10).6) Position the alignment fixture (pn 480-074-00) under the handler so that its pins capturea hole and slot in the interface assembly plate and a hole and slot in the small handlerbase plate (see Figure 10 and Figure 11).Align at these pointsfor dual site set-up.Align at these pointsfor single site set-up.Figure 11 Interface Alignment Fixture Position7) Move the loosely mounted interface assembly plate until all of the pins are engaged andit rests flush against the interface alignment fixture.8) Secure the alignment fixture to the interface assembly plate using the captive 1/4"-20hardware supplied with the fixture.9) Tighten the four interface plate mounting screws (from step 4) to 70 in-lbs.10) Remove and store the alignment fixture.11) Fasten the three spacers A, B and C (pn 480-227-48, 49, 50) to the interface assemblyplate if a 0.187-inch thick HIB is being used. (Use spacers 480-227-42, 43, 44) if a0.125" thick HIB is being used).Each spacer has a small groove and is marked with a letter. Align the letter on the spacerwith the corresponding letter on the interface assembly plate (see Figure 10).12) Secure the spacers by tighening the two captive 1/4"-20 screws in each to 70 in-lbs.15