Installation Guide - DATAQ Instruments

More documents

Recommendations

Info

Ethernet Hardware and Software Installation GuideSection C: Installing an Ethernet device directly connected toyour PC or connected via a hub or switch where ONLYDI-71x products are installedInstallation of an Ethernet device directly connected to the network card onyour computer requires you to change the IP address of your network card.NOTE: When installing your Ethernet device directly connected to yourPC you MUST use a crossover cable (provided). For hubs (below) that donot have an auto-switching sensor you must NOT use a crossover cable.Installation of an Ethernet device via an Ethernet hub/switch containingONLY DI-71x products also requires you to change the IP address of yournetwork card.1. Find the Network Connections on your computer (usually in theControl Panel).2. Double-click on the Local Area Connection icon.3. Click on the Properties button.8
Ethernet Hardware and Software Installation Guide4. Select Internet Protocol (TCP/IP) in the “This connection uses thefollowing items” window and click on the Properties button.5. Click on the General tab.6. Select the radio button Use the following IP address.7. Enter 169.254.0.1 in the space provided for the IP address.8. Enter 255.255.0.0 in the space provided for the Subnet mask.9
Page 5 and 6: USB Hardware and Software Installat
Page 10 and 11: Ethernet Hardware and Software Inst
Page 12 and 13: Ethernet Hardware and Software Inst
Page 14 and 15: Hardware and Software Installation
Page 16: DATAQ Instruments, Inc.241 Springsi

Installation Guide - DATAQ Instruments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?