ExtremeWare 7.0 Software Quick Reference ... - Extreme Networks

IGP CommandsCommandconfig isis system-identifier config isis [vlan | all] [level-1| level-2 |level-1-2] [passive | non-passive]config isis vlan [level-1 | level-2 |level-1-2] authentication [simple-password {no-check} | hmac-md5 {no-check} | none]config isis [vlan | all] [level-1| level-2 |level-1-2] cost config isis [vlan | all] [level-1| level-2 |level-1-2] hello-multiplier config isis [vlan | all] [level-1| level-2 |level-1-2] priority config isis [vlan | all] [level-1| level-2 |level-1-2] timer [csnp | hellotime]config ospf [area | vlan [ | all]] cost [automatic | ]config ospf [area | vlan [ | all]] priority config ospf [vlan | area | virtual-link ]authentication [simple-password | md5 | none | encrypted[simple-password | md5 ]config ospf [vlan | area | virtual-link ] timer {}Configures a 6 hex octet system identifier for IS-ISrouting.Configures the different IS-IS levels on a routinginterface as passive or non-passive.Configures authentication on a VLAN for the IS-ISlevels on a routing interface:Configures the IS-IS metric for the different IS-ISlevels of a routing interface.Configures the number of IS-IS Hello packets anIS-IS neighbor at a particular level on this routinginterface must miss before the it declares that theadjacency with this system is down.Configures the IS-IS priority for the IS-IS levels of arouting interface.Configures the IS-IS timer interval for the differentlevels of a routing interface.Configures the cost metric of one or all interface(s).Configures the priority used in the designatedrouter-election algorithm for one or all OSPFinterface(s) for all the interfaces within the area.Specifies the authentication password (up to eightcharacters) or Message Digest 5 (MD5) key for oneor all interfaces in an area.Configures the timers for one interface or allinterfaces in the same OSPF area.config ospf add virtual-link Adds a virtual link connected to another ABR.config ospf add vlan [ | all] area {passive}config ospf add vlan [ | all] area link-type [auto | broadcast | point-to-point]{passive}DescriptionEnables OSPF on one or all VLANs (routerinterfaces).Configures the OSPF link type.40 ExtremeWare 7.0.0 Software Quick Reference Guide